MC-78K0R-IE3 Renesas Electronics America, MC-78K0R-IE3 Datasheet - Page 14

• Manufacturer Part Number: MC-78K0R-IE3
• Description: KIT DEMO EVAL 78K0R IE3
• Manufacturer: Renesas Electronics America

Specifications of MC-78K0R-IE3

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MC-78K0R-IE3 KIT Evaluation System for Motor Control Microcontrollers
4. Motor Operation and Control
4.1 Standalone mode
6
The operation and control of the starter kit and motor can be done in two ways:
The motor can be operated in standalone mode right out of the box after the motor terminals and hall
sensor wires are connected and power is supplied. To operate in PC GUI mode a special NEC
Electronics program “necgui.exe” program has to be installed. See the installation instructions and
the operation in PC GUI mode in the following chapters of this user guide.
To run the motor in standalone mode, connect the 15V
SW7 power selector switch towards CN2. At this point the green POWER LED should turn on and
the 7-Segment LED should display “SELF”. This is an indication that the motor is ready to be
operated from the on-board pushbuttons and potentiometer.
After three seconds the LED will display the reference RPM and can be set to the desired speed
between 300 to 5000 RPM by the onboard potentiometer. The reference RPM is identified by the
decimal point lit on the units digit. If MODE button is pressed the display will toggle between


Standalone mode – with onboard pushbuttons, potentiometer and 7-Seg LED
PC mode – with a PC based GUI and the onboard USB connector
Figure 4. Power Up
DC
power supply to CN2 connector and flip