MC-78K0R-IE3 Renesas Electronics America, MC-78K0R-IE3 Datasheet - Page 18

• Manufacturer Part Number: MC-78K0R-IE3
• Description: KIT DEMO EVAL 78K0R IE3
• Manufacturer: Renesas Electronics America

Specifications of MC-78K0R-IE3

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MC-78K0R-IE3 KIT Evaluation System for Motor Control Microcontrollers
8. Drive and Motor Protection
9. Software Setup
10. Software Installation
10
The starter kit and the motor are protected against unexpected events such as overloads, motor stals
and malfunctions of the Hall sensors. If such faults are detected, the motor stops rotating and one of
the following fault conditions is displayed on the seven-segment LED.



The software CD-ROM accompanying this kit contains PDF versions of this document, the electrical
schematic of the MC-78K0R-IE3 KIT, the sample code to drive the BLDC motor and NEC
Electronics 78K0R firmware development tools environment. The software sample code is supplied
in source format and can be modified as needed.
The following sections describe NEC Electronics America’s development tools environment, how to
install it on your computer, and how to rebuild and download executable code to the
microcontroller’s flash memory.
Before proceeding with the tools installation, however, refer to all of the documentation on the CD-
ROM for information about the starter kit and follow the steps described in the following chapter.
8. Adjust the reference RPM with SPEED potentiometer. (During motor rotation, press MODE
8. While the motor is running press FORWARD or REVERSE to change direction.
9. To stop motor press START/STOP button once.
1. Insert the CD-ROM supplied with your MC-78K0R-IE3 KIT.
2. The CD-ROM should initialize automatically. If it doesn’t, click Start  Run. Browse to
3. Select MC-78K0R-IE3 KIT from the drop-down list.
Motor over-current:
Hall sensor fault:
Motor stall
button to switch the display between the REFERENCE RPM and the MEASURED RPM.)
your CD-ROM drive and select Motol_Control.exe.
‘O–C ‘
‘HALL’
‘FAIL’
(adjustable with R95 Trim potentiometer)
(malfunction, disconnected wiring)
(failure to spin)