MC-78K0R-IE3 Renesas Electronics America, MC-78K0R-IE3 Datasheet - Page 16

• Manufacturer Part Number: MC-78K0R-IE3
• Description: KIT DEMO EVAL 78K0R IE3
• Manufacturer: Renesas Electronics America

Specifications of MC-78K0R-IE3

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MC-78K0R-IE3 KIT Evaluation System for Motor Control Microcontrollers
4.2 PC Mode
5. Flash memory programming
6. Modes of Operation supported
8
MCU as well as programming of both the K0RIE3 and the 78K0/USB MCUs. A table showing the
configurations for various modes of operation is listed below.
The hardware can be configured to support standalone and PC operation, debugging of the K0RIE3
Programming the code into the microcontroller’s flash memory is achieved automatically when the
debugger is launched and the code is downloaded. To program the flash memory without the
debugger, a separate programmer GUI can be used with the existing USB interface (no extra
hardware is needed).
The flash programmer GUI is NEC WriteEZ4 and it is provided with the software installation CD.
Before launching the programmer, the board has to be reconfigured as follows:
To program the flash memory, consult the PG-FPL and WEZ4 user manuals.
Note: Alternate methods of debugging and programming the flash memory of the µPD78F1235
microcontroller are supported with NEC Electronics MINICUBE2 on-chip debug emulator and
programmer
the jumper configuration tables listed in Table 4 below.
In PC Mode the motor can be operated using a special GUI (Graphical User Interface) which can
be installed from the resource CD.
 DS1:
 JP5:
 JP6:
using the
1 OFF,
SHORT
3-4: SHORT
16-pin J2 connector. For details consult the MINICUBE2 user’s manual and
2 ON,
JP22: OPEN
JP7:
3-4: SHORT
3 ON,
4 OFF