AT91EB63 Atmel, AT91EB63 Datasheet - Page 12

• Manufacturer Part Number: AT91EB63
• Description: ARM M63200 & M43300 EVAL KIT
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: AT91 ARM Thumbr

Specifications of AT91EB63

• Contents: Evaluation Board, Cable, Power Jack, CD-ROM
• For Use With/related Products: AT91 63 & 43 Series
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The On-board Software
3.3
3.4
3.5
3-2
Programmed
Default Memory
Mapping
The SRAM
Downloader
The Angel
Monitor
The following table defines the mapping defined by the boot program.
Table 1. Memory Map
The boot program, FTS and SRAM Downloader are in sectors 1 and 2 of the Flash
device. Sectors 3 to 8 support the Angel Debug Monitor.
Sector 24 at address 0x0110 0000 must be programmed with a boot sequence to be
debugged. This sector can be mapped at address 0x0100 0000 (or 0x0 after a reset)
when the switch E7 is in the USER position.
The SRAM downloader allows an application to be loaded in the SRAM at the address
0x02000000, and then activates it. It is started by the boot if the SW2 button is pressed
at reset.
The procedure is as follows:
1. Connect the AT91EB63 Evaluation Board to the host PC serial A connection
2. Power on or press RESET, holding down the SW2 button at the same time. Wait
3. Start the BINCOM utility, available in the AT91 Library, on the host computer:
4. Press any button to end the download. The control is switched to the address
The Angel monitor is located in the Flash from 0x01002000 up to 0x0100FFFF. The
boot program starts it if no button is pressed at reset.
When the Angel starts, it recopies itself in SRAM, thus allowing it to run faster. The
SRAM used by the Angel is from 0x2020000 to 0x2040000, for example, the highest
half of the SRAM.
The Angel on the AT91EB63 Evaluation Board can be upgraded regardless of the ver-
sion programmed on it.
Note that if the debugger is started through ICE while the Angel monitor is on, the
Advanced Interrupt Controller (AIC) and the USART channels are configured and
running.
Part Name
MN1
MN2-MN3
using the straight serial cable provided.
for DS2 to light up and then release SW2.
Select the port for communications (COM1 or COM2, depending on where you con-
nected the serial cable on the host PC) and the baud rate for communications
(115200 bds, 1 stop, no parity).
Open the file to be downloaded and send it. Wait for the end of the transfer.
0x02000000.
Start Address
0x1000000
0x02000000
End Address
0x011FFFFF
0x02040000
AT91EB63 Evaluation Board User Guide
Size
2M Bytes
256K Bytes
SRAM
Device
Flash
AT91BV1604