FS-9005 Digi International, FS-9005 Datasheet - Page 23

• Manufacturer Part Number: FS-9005
• Description: JTAG-BOOSTER FOR ARM7TDMI 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9005

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ARM7TDMI, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The following options are valid for most functions:
/BIG
This option switches the byte ordering to big endian mode. This option must fit to
the target's endianess. Normally the target is configured to the right endianess
after reset. In some cases, the endianess can be changed within the
configuration file.
Default:
/CPUPOS=
Specifies the position of the ARM7TDMI within the JTAG chain.
Default:
/CFG=file
An configuration file may be specified. By default the current directory is
searched for the file JTAGARM7.CFG. If this file is not found and no
configuration file is specified in the command line, the target's memory is left
unchanged, i.e. the target's register remain in the reset state (see also chapter
1.8 “Configuration file JTAGARM7.”).
Default:
/DRIVER=x
A driver for the interface to the JTAG-BOOSTER on the parallel port may be
specified. /DRIVER=1 selects the fastest available driver, /DRIVER=4 selects
the slowest one. Use a slower driver if there are problems with JTAG-
BOOSTER.
Default:
/IROFFS=
Specifies the position of the ARM7TDMI instruction register within the JTAG
chain. In most cases this option is not needed.
Default:
/LATTICE /PPJARM /PLS /UNCBAS
Besides the standard JTAG-Booster interface there are several simple "Parallel-
Port-JTAG" interfaces supported. With this interfaces the programming
performance, of course, is reduced.
JTAG_ARM7TDMIa.doc
with x = 1,2,3,4
Little Endian
/CPUPOS=0
/CFG=JTAGARM7.CFG
/DRIVER=3
/IROFFS=0
23