FS-9005 Digi International, FS-9005 Datasheet - Page 28

• Manufacturer Part Number: FS-9005
• Description: JTAG-BOOSTER FOR ARM7TDMI 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9005

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ARM7TDMI, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2.
Usage:
The contents of a flash device is read and written to a file.
The type of the flash device is normally detected by the software. When
autodetection fails you should use the /DEVICE= option together with /8BIT or
/16BIT or /32BIT to set the right flash device and configuration. The known
devices are shown in chapter 1.9 “Supported flash devices”.
Options:
/DEVICE=devicename
See function /P (Chapter 2.1)
/8BIT /16BIT /32BIT
See function /P (Chapter 2.1)
/BYTE-MODE
See function /P (Chapter 2.1)
/NOMAN
See function /P (Chapter 2.1)
/DEVICE-BASE=hhhhhh
See function /P (Chapter 2.1)
/OFFSET=hhhhhh
Reading of the flash memory starts at an offset of hhhhhh relative to the start
address of the flash device. If the offset is negative, the offset specifies a
address relative to the end of the flash device.
See also option /TOP.
Default:
Abbreviation:
2
28
hhhhhh=number base is hex
Read a Flash Device to file
JTAGARM7 /R filename [optionlist]
/OFFSET=0
/O=
2
JTAG_ARM7TDMIa.doc