Z8F0123SB005EG Zilog, Z8F0123SB005EG Datasheet - Page 89

• Manufacturer Part Number: Z8F0123SB005EG
• Description: IC ENCORE MCU FLASH 1K 8SOIC
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F0123SB005EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, POR, PWM, WDT
• Number Of I /o: 6
• Program Memory Size: 1KB (1K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: 269-3757

PS024314-0308
Reading the Timer Count Values
Timer Pin Signal Operation
2. Write to the Timer High and Low Byte registers to set the starting count value
3. Write to the Timer Reload High and Low Byte registers to set the Compare value.
4. Enable the timer interrupt, if appropriate, and set the timer interrupt priority by writing
5. Configure the associated GPIO port pin for the Timer Input alternate function.
6. Write to the Timer Control register to enable the timer.
7. Counting begins on the first appropriate transition of the Timer Input signal. No
In CAPTURE/COMPARE mode, the elapsed time from timer start to Capture event can be
calculated using the following equation:
The current count value in the timers can be read while counting (enabled). This capability
has no effect on timer operation. When the timer is enabled and the Timer High Byte
register is read, the contents of the Timer Low Byte register are placed in a holding
register. A subsequent read from the Timer Low Byte register returns the value in the hold-
ing register. This operation allows accurate reads of the full 16-bit timer count value while
enabled. When the timers are not enabled, a read from the Timer Low Byte register returns
the actual value in the counter.
Timer Output is a GPIO port pin alternate function. The Timer Output is toggled every
time the counter is reloaded.
The timer input can be used as a selectable counting source. It shares the same pin as the
complementary timer output. When selected by the GPIO Alternate Function Registers,
this pin functions as a timer input in all modes except for the DUAL PWM OUTPUT
mode. For this mode, there is no timer input available.
–
–
–
(typically
to the relevant interrupt registers.By default, the timer interrupt are generated for both
input Capture and Reload events. If appropriate, configure the timer interrupt to be
generated only at the input Capture event or the Reload event by setting TICONFIG
field of the TxCTL1 register.
interrupt is generated by this first edge.
Capture Elapsed Time (s)
Configure the timer for CAPTURE/COMPARE mode
Set the prescale value
Set the Capture edge (rising or falling) for the Timer Input
0001H
).
=
(
----------------------------------------------------------------------------------------------------------------------- -
Capture Value Start Value
System Clock Frequency (Hz)
–
Z8 Encore! XP
) Prescale
Product Specification
×
®
F0823 Series
Timers
79