PIC16LC433T-I/SO Microchip Technology, PIC16LC433T-I/SO Datasheet - Page 45

• Manufacturer Part Number: PIC16LC433T-I/SO
• Description: IC MCU CMOS 8BIT 10MHZ 2K 18SOIC
• Manufacturer: Microchip Technology
• Series: PIC® 16Cr

Specifications of PIC16LC433T-I/SO

• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: LIN (Local Interconnect Network)
• Peripherals: POR, WDT
• Number Of I /o: 6
• Program Memory Size: 3.5KB (2K x 14)
• Program Memory Type: OTP
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 18-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

The ADRES Register contains the result of the A/D
conversion. When the A/D conversion is complete, the
result is loaded into the ADRES register, the GO/DONE
bit (ADCON0<2>) is cleared and A/D interrupt flag bit
ADIF (PIE1<6>) is set. The block diagrams of the A/D
module are shown in Figure 8-1.
After the A/D module has been configured as desired,
the selected channel must be acquired before the con-
version is started. The analog input channels must
have their corresponding TRIS bits selected as an
input. To determine sample time, see Section 8.1. After
this acquisition time has elapsed, the A/D conversion
can be started. The following steps should be followed
for doing an A/D conversion:
1.
FIGURE 8-1:
2001 Microchip Technology Inc.
Configure the A/D module:
• Configure analog pins/voltage reference/ and
• Select A/D input channel (ADCON0)
• Select A/D conversion clock (ADCON0)
• Turn on A/D module (ADCON0)
digital I/O (ADCON1 and TRIS)
Converter
A/D
A/D BLOCK DIAGRAM
(Reference
Voltage)
V
REF
(Input Voltage)
Advance Information
PCFG<2:0>
V
IN
V
DD
2.
3.
4.
5.
6.
7.
Configure A/D interrupt (if desired):
• Clear ADIF bit
• Set ADIE bit
• Set GIE bit
Wait the required acquisition time.
Start conversion:
• Set GO/DONE bit (ADCON0)
Wait for A/D conversion to complete, by either:
• Polling for the GO/DONE bit to be cleared
OR
• Waiting for the A/D interrupt
Read A/D Result Register (ADRES), clear bit
ADIF if required.
For the next conversion, go to step 1, step 2, or
step 3, as required. The A/D conversion time per
bit is defined as T
required before next acquisition starts.
CHS<1:0>
11
10
01
00
AD
. A minimum wait of 2T
PIC16C433
DS41139A-page 43
GP2/AN2
GP1/AN1/V
GP0/AN0
GP4/AN3
AD
REF
is