M30620FCAFP#U5 Renesas Electronics America, M30620FCAFP#U5 Datasheet - Page 523

• Manufacturer Part Number: M30620FCAFP#U5
• Description: IC M16C MCU FLASH 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30620FCAFP#U5

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: M16C
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 87
• Interface Type: SIM/UART
• On-chip Adc: 10-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 11
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Timer A Applications
2-204
3.4 Buzzer Output
Overview
Specifications
Operation
Figure 3.4.1. Operation timing of buzzer output
Timer A0
overflow timing
Count start flag
Pulse output
function select bit
P7
0
output
The timer mode is used to make the buzzer ring. Figure 3.4.1 shows the operation timing, and
Figure 3.4.2 shows the set-up procedure.
Use the following peripheral function:
• The pulse-outputting function in timer mode of timer A.
(1) Sound a 2-kHz buzz beep by use of timer A0.
(2) Effect pull-up in the relevant port by use of a pull-up resistor. When the buzzer is off, set the
(3) Connect a 16-MHz oscillator to X
(1) The microcomputer begins performing a count on timer A0. Timer A0 has disabled interrupts.
(2) The microcomputer begins pulse output by setting the pulse output function select bit to
(3) The microcomputer stops outputting pulses by setting the pulse output function select bit to
port high-impedance, and stabilize the potential resulting from pulling up.
“Pulse output effected”. P7
“Pulse output not effected”. P7
high-impedance.
“1”
“0”
“1”
“0”
“1”
“0”
(1) Start count
High-impedance
0
changes into TA0
0
goes to an input pin, and the output from the pin becomes
IN
.
(2) Buzzer output ON
OUT
pin and outputs 2-kHz pulses.
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
(3) Buzzer output OFF
High-impedance
M16C / 62A Group
Mitsubishi microcomputers