ATTINY12V-1PC Atmel, ATTINY12V-1PC Datasheet - Page 21
![IC AVR MCU 1MHZ 1.8V 8DIP](/photos/6/50/65033/313-8-dip_sml.jpg)
ATTINY12V-1PC
Manufacturer Part Number
ATTINY12V-1PC
Description
IC AVR MCU 1MHZ 1.8V 8DIP
Manufacturer
Atmel
Series
AVR® ATtinyr
Specifications of ATTINY12V-1PC
Core Processor
AVR
Core Size
8-Bit
Speed
1.2MHz
Peripherals
POR, WDT
Number Of I /o
6
Program Memory Size
1KB (512 x 16)
Program Memory Type
FLASH
Eeprom Size
64 x 8
Voltage - Supply (vcc/vdd)
1.8 V ~ 5.5 V
Oscillator Type
Internal
Operating Temperature
0°C ~ 70°C
Package / Case
8-DIP (0.300", 7.62mm)
Data Bus Width
8 bit
Maximum Clock Frequency
8 MHz
Number Of Programmable I/os
6
Number Of Timers
1
Operating Supply Voltage
1.8 V to 5.5 V
Maximum Operating Temperature
+ 85 C
Mounting Style
Through Hole
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Ram Size
-
Data Converters
-
Connectivity
-
Lead Free Status / Rohs Status
No
Other names
ATTINY12V1PC
ATtiny11/12
reset (if enabled), an external level interrupt (INT0), or a pin change interrupt can wake
up the MCU.
Note that if a level triggered or pin change interrupt is used for wake-up from Power-
down Mode, the changed level must be held for a time to wake up the MCU. This makes
the MCU less sensitive to noise. The wake-up period is equal to the clock-counting part
of the reset period (See Table 10). The MCU will wake up from the power-down if the
input has the required level for two watchdog oscillator cycles. If the wake-up period is
shorter than two watchdog oscillator cycles, the MCU will wake up if the input has the
required level for the duration of the wake-up period. If the wake-up condition disap-
pears before the wake-up period has expired, the MCU will wake up from power-down
without executing the corresponding interrupt. The period of the watchdog oscillator is
2.7 µs (nominal) at 3.0V and 25°C. The frequency of the watchdog oscillator is voltage
dependent as shown in the section “ATtiny11 Typical Characteristics” on page 62.
When waking up from Power-down Mode, there is a delay from the wake-up condition
occurs until the wake-up becomes effective. This allows the clock to restart and become
stable after having been stopped. The wake-up period is defined by the same CKSEL
fuses that define the reset time-out period.
21
1006F–AVR–06/07