MC68HC908AB32CFU Freescale Semiconductor, MC68HC908AB32CFU Datasheet - Page 153

• Manufacturer Part Number: MC68HC908AB32CFU
• Description: IC MCU 8MHZ 32K FLASH 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908AB32CFU

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI, SPI
• Peripherals: POR, PWM
• Number Of I /o: 51
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

9.10.2 Parametric Influences On Reaction Time
MC68HC908AB32
Freescale Semiconductor
—
Rev. 1.1
Obviously, the acquisition and lock times can vary according to how
large the frequency error is and may be shorter or longer in many cases.
Acquisition and lock times are designed to be as short as possible while
still providing the highest possible stability. These reaction times are not
constant, however. Many factors directly and indirectly affect the
acquisition time.
The most critical parameter which affects the reaction times of the PLL
is the reference frequency, f
detector and controls how often the PLL makes corrections. For stability,
the corrections must be small compared to the desired frequency, so
several corrections are required to reduce the frequency error.
Therefore, the slower the reference the longer it takes to make these
corrections. This parameter is also under user control via the choice of
crystal frequency f
Another critical parameter is the external filter capacitor. The PLL
modifies the voltage on the VCO by adding or subtracting charge from
this capacitor. Therefore, the rate at which the voltage changes for a
given frequency error (thus change in charge) is proportional to the
capacitor size. The size of the capacitor also is related to the stability of
the PLL. If the capacitor is too small, the PLL cannot make small enough
adjustments to the voltage and the system cannot lock. If the capacitor
is too large, the PLL may not be able to adjust the voltage in a
reasonable time. See
•
Lock time, t
between the actual output frequency and the desired output
frequency to less than the lock mode entry tolerance ∆
time is based on an initial frequency error, (f
not more than ±100%. In automatic bandwidth control mode, lock
time expires when the LOCK bit becomes set in the PLL
bandwidth control register (PBWC). See
Automatic PLL Bandwidth
Clock Generator Module (CGM)
LOCK
XCLK
9.10.3 Choosing a Filter
, is the time the PLL takes to reduce the error
.
RDV
. This frequency is the input to the phase
Modes.
Clock Generator Module (CGM)
9.4.2.3 Manual and
Capacitor.
DES
– f
ORIG
Technical Data
LOCK
)/f
DES
. Lock
, of
153