78M6612-IGTR/F Maxim Integrated Products, 78M6612-IGTR/F Datasheet - Page 45
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
78M6612-IGTR/F
Manufacturer Part Number
78M6612-IGTR/F
Description
IC POWER MEASUREMENT AC 64-LQFP
Manufacturer
Maxim Integrated Products
Datasheet
1.78M6612-IMF.pdf
(111 pages)
Specifications of 78M6612-IGTR/F
Mounting Style
SMD/SMT
Package / Case
LQFP-64
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
78M6612-IGTR/F
Manufacturer:
Maxim Integrated
Quantity:
10 000
DS_6612_001
1.5.8 LCD Drivers
The device in the 68-pin QFN package contains 20 dedicated LCD segment drivers in addition to the 18
multi-use pins described above. Thus, the device is capable of driving between 80 to 152 pixels of LCD
display with 25% duty cycle (or 60 to 114 pixels with 33% duty cycle). At eight pixels per digit, this
corresponds to 10 to 19 digits.
The device in the 64-pin LQFP package contains 18 dedicated LCD segment drivers in addition to the 17
multi-use pins described above. Thus, the device is capable of driving between 72 to 140 pixels of LCD
display with 25% duty cycle (or 60 to 105 pixels with 33% duty cycle). At eight pixels per digit, this
corresponds to 9 to 17 digits.
The LCD drivers are grouped into four commons and up to 38 segment drivers (68-pin package), or 4
commons and 35 segment drivers (64-pin package). The LCD interface is flexible and can drive either
digit segments or enunciator symbols.
Segment drivers SEG18 and SEG19 can be configured to blink at either 0.5 Hz or 1 Hz. The blink rate
is controlled by LCD_Y. There can be up to four pixels/segments connected to each of these drivers.
LCD_BLKMAP18[3:0] and LCD_BLKMAP19[3:0] identify which pixels, if any, are to blink.
1.5.9 Battery Monitor
The battery voltage is measured by the ADC during alternative MUX frames if the BME (Battery Measure
Enable) bit is set. While BME is set, an on-chip 45 kΩ load resistor is applied to the battery and a scaled
fraction of the battery voltage is applied to the ADC input. After each alternative MUX frame, the result of
the ADC conversion is available at CE DRAM address 0x07. BME is ignored and assumed zero when
system power is not available. See
and the conversion accuracy.
Rev. 1.2
LCD interface memory is powered by the non-volatile supply. The bits of the LCD memory
are preserved in LCD and SLEEP modes, even if their pin is not configured as SEG. In this
case, they can be useful as general- purpose non-volatile storage.
Table 40: Selectable Controls using the DIO_DIR Bits
DIO_R Value
0
1
2
3
4
5
6
7
Section 5.4.4 Battery Monitor
High priority I/O interrupt (INT0 falling)
Resource Selected for DIO Pin
NONE
Reserved
T0 (counter0 clock)
T1 (counter1 clock)
High priority I/O interrupt (INT0 rising)
Low priority I/O interrupt (INT1 rising)
Low priority I/O interrupt (INT1 falling)
for details regarding the ADC LSB size
78M6612 Data Sheet
45