STEVAL-SPBT2ATV1 STMicroelectronics, STEVAL-SPBT2ATV1 Datasheet - Page 33

• Manufacturer Part Number: STEVAL-SPBT2ATV1
• Description: BOARD DEMO BLUETOOTH SPBT2532C2
• Manufacturer: STMicroelectronics
• Type: Bluetooth 2.0r

Specifications of STEVAL-SPBT2ATV1

• Frequency: 2.4GHz
• Product: RF Modules
• Supply Voltage (max): 6 V
• Maximum Operating Temperature: + 85 C
• Supply Voltage (min): 4 V
• For Use With/related Products: SPBT2532C2
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Other names: 497-10656

SPBT2532C2.AT
D.12.2
D.13
D.13.1
D.13.2
D.14
D.14.1
D.14.2
Responses
If the operation is successful, the response is:
AT-AB BondEnabled
If bonding has been initiated by a remote device, the notification is:
AT-AB BondPending [BD addr]
where [BD addr] is the BD address of the remote device that initiated the bonding.
If bonding has occurred, the notification is:
AT-AB BondOk [BD addr]
where [BD addr] is the BD address of the remote device with successful bonding.
If bonding was initiated by a remote device but failed, the notification is
AT-AB BondFail
When the time limit for bonding has expired, the notification is
AT-AB BondDisabled
EraseBondTable
The EraseBondTable command is used to erase all of the bonded device entries. Single
devices cannot be erased with this command
Syntax
AT+AB EraseBondTable
Responses
If the operation is successful, the response is:
AT-AB BondTableErased
GetBDAddress
The GetBDAddress command is used to read the local device’s Bluetooth Device Address
or MAC address.
Syntax
AT+AB GetBDAddress
Responses
If the operation is successful, the response is:
AT-AB BD_ADDR = [BD address]
Doc ID 16089 Rev 7
Command description
33/50