STEVAL-SPBT2ATV1 STMicroelectronics, STEVAL-SPBT2ATV1 Datasheet - Page 46
![BOARD DEMO BLUETOOTH SPBT2532C2](/photos/14/13/141375/steval-spbt2atv1_sml.jpg)
STEVAL-SPBT2ATV1
Manufacturer Part Number
STEVAL-SPBT2ATV1
Description
BOARD DEMO BLUETOOTH SPBT2532C2
Manufacturer
STMicroelectronics
Type
Bluetooth 2.0r
Specifications of STEVAL-SPBT2ATV1
Frequency
2.4GHz
Product
RF Modules
Supply Voltage (max)
6 V
Maximum Operating Temperature
+ 85 C
Supply Voltage (min)
4 V
For Use With/related Products
SPBT2532C2
Lead Free Status / RoHS Status
Lead free by exemption / RoHS compliant by exemption
Other names
497-10656
Other responses
Appendix F
F.1
F.2
F.3
46/50
The following subsections describe the 4 types of responses that occur under specific
circumstances, not necessarily as a result of a specific command. They are:
●
●
●
●
Reset
Upon either hardware reset or software reset (such as the Reset command), abSerial will
respond as follows after the reset is complete:
AT-AB -CommandMode-
AT-AB BDAddress [BD addr]
Because the BD address of the local device is reported during this response, the response
is different than a response to the Escape Sequence.
Escape sequence
If the Escape sequence, ^#^$^%, is received and no connection is active, abSerial will
immediately respond with:
AT-AB -CommandMode-
When the Escape Sequence is received while a connection is still active and there is no
data for 2 seconds, abSerial will respond (after those 2 seconds of no data) with the same
string.
abSerial will now be in command mode.
Controlled disconnect
If the local host initiates a disconnect, it must first put the abSerial interface into command
mode (see the section on Escape Sequence directly above). After a successful disconnect
command, the following response is made:
AT-AB ConnectionDown
Reset
Escape sequence
Controlled disconnect
Unexpected disconnect
Other responses
Doc ID 16089 Rev 7
SPBT2532C2.AT