RN-111B-EVAL Roving Networks Inc, RN-111B-EVAL Datasheet - Page 7

• Manufacturer Part Number: RN-111B-EVAL
• Description: EVALUATION KIT FOR WIFLY MODULE
• Manufacturer: Roving Networks Inc
• Type: WiFly 802.11br

Specifications of RN-111B-EVAL

• Frequency: 2.4GHz
• Wireless Frequency: 50 Hz to 60 Hz
• Interface Type: USB, Serial, SMA
• Operating Voltage: 5 VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 740-1027

Trouble Shooting
WiFly Utility error “Can not find sensor: Timeout”
WiFly Utility error “Command scan: Timeout”
WiFly Utility error “No Networks Found”
WiFly module red LED remains on after setting SSID and channel
WiFly Module red LED is off, but green LED is flash quickly
The Bluetooth trademark and logo are registered trademarks of Bluetooth SIG, Inc. All other trademarks are
property of their respective owners.
809 University Avenue
The evaluation board is not connected. Check to make sure the jumpers are correctly set for
USB or Serial connection.
The Wifly module is not able to find any networks in range. Check that the WiFly utility
Channel field is set to Auto Find. Make sure the network access point as good signal
strength
The Wifly module can not connect to the networks. Possible problems include, no access
points available, check with wireless device manager. Incorrect or missing WEP key, confirm
access point is either open (no security) or you have the right authentication level set and the
correct pass phrase or key.
The Wifly module can not connect to the networks. Possible problems include, not saving
the configuration before rebooting, enter command mode and verify settings. Incorrect or
missing WEP/WPA keys, confirm access point is either open (no security) or you have the
right authentication level set and the correct pass phrase or key.
The WiFy module is associated with the network but was unable to get an IP address. Check
the DHCP is ON in WiFly configuration. If using a static IP address make sure the sub-net
mask and the gateway IP addresses are set correctly using the get ip command
Copyright © 2009 Roving Networks. All rights reserved.
•
Los Gatos, CA 95032
•
Tel [phone]
RN-111B-EVAL
IGRN111B-EVAL 3/10/2009
• [e-mail]