ATA5812-PLQ Atmel, ATA5812-PLQ Datasheet - Page 49
![IC TXRX UHF ASK/FSK 1CH 48-QFN](/photos/7/34/73471/48-vqfn-6_543-5130_01-4_sml.jpg)
ATA5812-PLQ
Manufacturer Part Number
ATA5812-PLQ
Description
IC TXRX UHF ASK/FSK 1CH 48-QFN
Manufacturer
Atmel
Datasheet
1.ATA5811-PLHC.pdf
(92 pages)
Specifications of ATA5812-PLQ
Frequency
315MHz
Data Rate - Maximum
20kbps
Modulation Or Protocol
ASK, FSK
Applications
Access Control, AMR, RKE
Sensitivity
-116dBm
Voltage - Supply
2.4 V ~ 3.6 V or 4.4 V ~ 6 V
Current - Receiving
10.5mA
Current - Transmitting
10.5mA
Data Interface
PCB, Surface Mount
Antenna Connector
PCB, Surface Mount
Operating Temperature
-40°C ~ 105°C
Package / Case
48-VQFN Exposed Pad, 48-HVQFN, 48-SQFN, 48-DHVQFN
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Power - Output
-
Memory Size
-
Other names
ATA5812-PLQTR
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ATA5812-PLQW
Manufacturer:
ATMEL
Quantity:
962
Figure 10-7. Serial Timing
11. Operation Modes
11.1
4689F–RKE–08/06
RX Operation
SDO_TMDO
SDI_TMDI
SCK
CS
T
SCK_setup1
X
X can be either V
The transceiver is set to RX operation with the bits OPM0 and OPM1 in control register 1
Table 11-1.
The transceiver is designed to consume less than 1 mA in RX operation while being sensitive to
signals from a corresponding transmitter. This is achieved via the polling circuit. This circuits
enables the signal path periodically for a short time. During this time the Bit-check logic verifies
the presence of a valid transmitter signal. Only if a valid signal is detected the transceiver
remains active and transfers the data to the connected microcontroller. This transfer take place
either via the TX/RX data buffer or via the pin SDO_TMDO. If there is no valid signal present the
transceiver is in sleep mode most of the time resulting in low current consumption. This condition
is called RX polling mode. A connected microcontroller can be disabled during this time.
All relevant parameters of the polling logic can be configured by the connected microcontroller.
This flexibility enables the user to meet the specifications in terms of current consumption, sys-
tem response time, data rate etc.
In RX mode the RF transceiver is enabled permanently and the Bit-check logic verifies the pres-
ence of a valid transmitter signal. If a valid signal is detected the transceiver transfers the data to
the connected microcontroller. This transfer take place either via the TX/RX data buffer or via
the pin SDO_TMDO.
X
T
T
T
Setup
CS_setup
Out_enable
OPM1
1
1
iI
or V
Control Register 1
MSB
T
Hold
MSB
iH
T
Cycle
T
X
Out_delay
MSB-1
OPM0
0
1
MSB-1
X
ATA5811/ATA5812
LSB
T
SCK_setup2
RX polling mode
X
Function
RX mode
T
T
CS_disable
Out_disable
T
X
SCK_hold
49