XBP09-DPUIT-156 Digi International, XBP09-DPUIT-156 Datasheet - Page 51

• Manufacturer Part Number: XBP09-DPUIT-156
• Description: MODULE XBEE PRO W/U.FL
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP09-DPUIT-156

• Frequency: 902MHz ~ 928MHz
• Data Rate - Maximum: 156kbps
• Modulation Or Protocol: FHSS
• Applications: ISM
• Power - Output: 17dBm (50mW)
• Sensitivity: -100dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 80mA
• Current - Transmitting: 210mA
• Data Interface: PCB, Through Hole
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1168

XBee‐PRO® 900 RF Modules
Remote AT Command Request
Frame Type: 0x17
Used to query or set module parameters on a remote device. For parameter changes on the
remote device to take effect, changes must be applied, either by setting the apply changes options
bit, or by sending an AC command to the remote.
Example: The above example sends a remote command to change the broadcast hops register on
a remote device to 1 (broadcasts go to 1-hop neighbors only), and apply changes so the new
configuration value immediately takes effect. In this example, the 64-bit address of the remote is
0x0013A200 40401122.
A
P
I
P
a
c
k
e
t
© 2009 Digi International, Inc.
Start Delimiter
Length
Frame-specific Data
Checksum
Frame Fields
Frame Type
Frame ID
64-bit Destination
Address
Reserved
Remote Command
Options
AT Command
Command Parameter
Offset Example
LSB 12 0x22
MSB 1 0x00
MSB 5 0x00
LSB 2 0x10
10 0x40
13 0xFF
14 0xFE
15
16 0x42 (B)
17 0x48 (H)
18 0x01
18 0xF5
11 0x11
0 0x7E
3 0x17
4 0x01
6 0x13
7 0xA2
8 0x00
9 0x40
0x02 (apply
changes)
Number of bytes between the length and the checksum
Identifies the UART data frame for the host to correlate
with a subsequent ACK (acknowledgement). If set to 0,
no response is sent.
Set to the 64-bit address of the destination device. The
following address is also supported:
0x000000000000FFFF - Broadcast address
Set to 0xFFFE.
0x02 - Apply changes on remote. (If not set, AC
command must be sent before changes will take effect.)
All other bits must be set to 0.
Name of the command
If present, indicates the requested parameter value to set
the given register. If no characters present,
the register is queried.
0xFF - the 8 bit sum of bytes from offset 3 to this byte.
Description
51