XRD9836ACG Exar Corporation, XRD9836ACG Datasheet - Page 10

• Manufacturer Part Number: XRD9836ACG
• Description: IC 16B CCD/CIS SIG PROC 48TSSOP
• Manufacturer: Exar Corporation

Specifications of XRD9836ACG

• Package / Case: 48-TSSOP (0.240", 6.10mm Width)
• Number Of Bits: 16
• Number Of Channels: 3
• Power (watts): 500mW
• Voltage - Supply, Analog: 3 V ~ 3.6 V
• Voltage - Supply, Digital: 3 V ~ 3.6 V
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Contains lead / RoHS Compliant

xr
xr
XRD9836
16-BIT PIXEL GAIN AFE
REV. 1.0.0
SYSTEM OVERVIEW
The XRD9836 provides a 16-bit Analog Front End
functionality for Mid-to-High range, next-generation
scanner applications. It has 3 channels of Correlated
Double Sampling (CDS), using a 10-bit Dynamic Off-
set DAC, a 10-bit Programmable Gain Amplifier
(PGA) and a 10-bit Fine Offset DAC for Red, Green,
and Blue CCD signals. A 16-bit 30MHz ADC is multi-
plexed among these 3 channels to provide digitized
image data for the scanner ASIC chip. In 3-channel
mode, the order of channels is R, G, B. In the 1-chan-
nel mode, only the selected channel is active. The
XRD9836 provides one of the key requirements for
the next generation scanner AFE’s, the ability to con-
trol Pixel-by-Pixel Gain and Offset values. Figure 3
shows the ASIC and AFE interface for the proposed
system.
A 10-bit parallel bus Offset Gain Input Port (OGI) is
used to transfer 10 bits of Gain and 10 bits of Offset.
In the 3-channel mode, the data is received sequen-
tially in the following order: red gain, red offset, green
gain, green offset, blue gain, blue offset. In 1-channel
mode, the data is received sequentially gain then off-
set. For an example of both 3-channel and 1-channel
OGI timing see Figure 4.
The Input Enable pin (IE) enables OGI port to pro-
gram internal pixel gain and offset registers. If IE
goes low, the gain and offset registers will store the
last data while IE was high.
For ADC outputs, the XRD9836 has an 8-bit parallel
bus ADC Data Out (ADCDO). The ADC output data is
transmitted sequentially in the following order for 3-ch
mode red high order byte, red low order byte, green
high order byte, green low order byte, blue high order
byte, blue low order byte as shown in Figure 5
A three-pin, Micro-controller Serial I/O link (uSIO) is
used to write or read from the XRD9836’s internal
configuration registers. The internal registers control
the various modes of operation of the chip.
F
3. S
B
D
IGURE
YSTEM
LOCK
IAGRAM
10