LS027B7DH01 Sharp Microelectronics, LS027B7DH01 Datasheet - Page 8

• Manufacturer Part Number: LS027B7DH01
• Description: LCD Graphic Display Modules & Accessories 2.7 WQVGA HR-TFT 400x240 w/FPC
• Manufacturer: Sharp Microelectronics

Specifications of LS027B7DH01

• Pixel Density: 400 x 240
• Module Size (w X H X T): 62.8 mm x 42.82 mm
• Viewing Area (w X H): 58.8 mm x 35.28 mm
• Operating Temperature Range: - 20 C to + 70 C
• Attached Touch Screen: No
• Product: 2.7 in WQVGA Monochrome
• Display Mode: Transmissive
• Interface: Serial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

FPC
LCD Panel
(1) Operation outside specified environmental conditions cannot be guaranteed.
(2) As power supply (VDD-GND、VDDA-GND) impedance is lowered during use, bus controller should be inserted
(3) Polarizer film is applied over LCD panel surface. Liquid crystal inside LCD panel deteriorates with ultraviolet ray.
(4) Disassembling the LCD module will cause permanent damage to the module. Do not disassemble the module.
(5) If LCD panel is broken, do not ingest the liquid crystal from the broken panel. If hand, leg, or clothes come in
(6) ODS (specific chlorofuorocarbon, specific halon, 1-1-1 trichloroethane, carbon tetrachloride) are not used or
(7) Observe all other precautionary requirements in handling general electronic components.
near LCD module as much as possible.
The panel should not be left in direct sun or under strong ultraviolet ray for prolonged period of time even with the
polarizer film.
contact with liquid crystal, wash off immediately with soap.
contained in material or all production processes of this product.
:
: Dispose of as glass waste. This LCD module contains no harmful substances.
(approximately 100mg) and therefore it will not leak even if the panel should break.
(Aims test: negative) material is used.
The liquid crystal panel contains no dangerous or harmful substances.
This liquid crystal panel contains only an extremely small amount of liquid crystal
Its median lethal dose (LD50) is greater than 2,000 mg/kg and a mutagenetic
(1) FPC bend R should be 0.45mm or greater and R should be even.
(2) Do not hang LCD module by FPC or apply force to FPC.
In LCD panel an connective area, do not bend FPC into polarizer film side.
Discarding liquid crystal modules
SPEC No.
LCY-1210401A
[Other Notice]
MODEL No.
LS027B7DH01
PAGE
5