LQ022B8UD05 Sharp Microelectronics, LQ022B8UD05 Datasheet - Page 5

• Manufacturer Part Number: LQ022B8UD05
• Description: TFT Displays & Accessories 2.2 5.58cm Module 176 x RGB x 220
• Manufacturer: Sharp Microelectronics

Specifications of LQ022B8UD05

• Diagonal: 2.2 in
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 20 C
• Operating Temperature Range: - 20 C to + 70 C
• Product: Displays
• Touch Panel: No Touch Panel
• Viewing Area (w X H): 34.848 mm x 43.56 mm
• Pixel Density: 176 x 220
• Module Size (w X H X T): 42.1 mm x 56.6 mm x 4.2 mm
• Backlighting: White
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

(11) Hold LCD very carefully when placing LCD module into the system housing. Do not apply excessive stress or pressure
(12) Do not hold or touch LCD panel to flex interconnection area as it may be damaged.
(13) As the binding material between LCD panel and flex connector mentioned in 12) contains an organic material, any type
(14) When carrying the LCD module, place it on the tray to protect from mechanical damage. It is recommended to use the
(15) Do not touch the COG’s patterning area. Otherwise the circuit may be damaged.
(16) Do not touch LSI chips as it may cause a trouble in the inner lead connection.
(17) Place a protective cover on the LCD module to protect the glass panel from mechanical damages.
(18) LCD panel is susceptible to mechanical stress and even the slightest stress will cause a color change in background. So
(19) Protective film is placed onto the surface of LCD panel when it is shipped from factory. Make sure to peel it off before
③ Floor
④ Humidity
⑤ Transportation/storage
⑥ Others
to LCD module. Do not to use chloroprene rubber as it may affect on the reliability of the electrical interconnection.
of organic solvents are not allowed to be used. Direct contact by fingers is also prohibited.
conductive trays to protect the CMOS components from electrostatic discharge. When holding the module, hold the Plastic
Frame of LCD module so that the panel, COG and other electric parts are not damaged.
make sure the LCD panel is placed on flat plane without any continuous twisting, bending or pushing stress.
assembling the LCD module into the system. Be very careful not to damage LCD module by electrostatic discharge when
charge up and discharge. Equipment must be grounded through 100Mohms resistance. Use ion blower.
Floor is an important part to leak static electricity which is generated from human body or equipment.
There is a possibility that the static electricity is charged to them without leakage in case of insulating floor, so the
countermeasure (electrostatic earth:1×10
Proper humidity of working room may reduce the risk of electrostatic charge up and discharge. Humidity should be kept
over 50% all the time.
Storage materials must be anti-static to prevent causing electrostatic discharge.
Protective film is attached on the surface of LCD panel to prevent scratches or other damages. When removing this
protective film, remove it slowly under proper anti-ESD control such as ion blower.
8
Ω) should be made.
SPEC No.
LCP-05032A
MODEL No.
LQ022B8UD05
PAGE
2