LE24L042CS-LV-TFM-E SANYO, LE24L042CS-LV-TFM-E Datasheet - Page 6

• Manufacturer Part Number: LE24L042CS-LV-TFM-E
• Description: IC EEPROM 4KBIT 400KHZ WLP4
• Manufacturer: SANYO

Specifications of LE24L042CS-LV-TFM-E

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 4K (512 x 8)
• Speed: 400kHz
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 1.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 4-WLP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 869-1230-2

4 Acknowledge
5 Device addressing
During data transfer, 8 bits are transferred in succession, and then in the ninth clock cycle period the device on the
system bus receiving the data sets the SDA line to low, and sends the acknowledge signal indicating that the data has
been received. The acknowledge signal is not sent during an EEPROM internal write operation.
For the purposes of communication, the master device in the system generates the start condition for the slave device.
Communication with a particular slave device is enabled by sending along the SDA bus the device address, which is 7
bits long, and the read/write command code, which is 1 bit long, immediately following the start condition.
The upper four bits of the device address are called the device code which, for this product, is fixed as “1010.” This
device has the upper 2-bit of the Slave Device address as the Slave address (S1, S2), which fixed internally. The value
of Slave address are S1=0, S2=0.
When the device code input from SDA and the slave addresses are compared with the product’s device code and slave
addresses that were set at the mounting stage and found to match, the product sends the acknowledge signal during
the ninth clock cycle period, and initiates the read or write operation in accordance with the read or write command
code. If they do not match, the EEPROM returns to standby mode. When a read operation is performed immediately
after the slave device has been switched, the random read command must be used.
SCL
(EEPROM input)
SDA
(Master output)
SDA
(EEPROM output)
LE24L042CS
MSB
1
Start
condition
Device Code
0
1
LE24L042CS
1
Device address word
0
S2
Slave
Address
S1
8
Memory
Address
A8
Acknowledge
bit output
t AA
R/W
LSB
9
No.A1440-6/10
t DH