MB96F387RSBPMC-GSE2 Fujitsu, MB96F387RSBPMC-GSE2 Datasheet - Page 136

• Manufacturer Part Number: MB96F387RSBPMC-GSE2
• Description: IC, 16BIT MCU, F2MC-16FX, 56MHZ LQFP-120
• Manufacturer: Fujitsu

Specifications of MB96F387RSBPMC-GSE2

• Controller Family/series: F2MC-16FX
• No. Of I/o's: 96
• Ram Memory Size: 16KB
• Cpu Speed: 56MHz
• No. Of Timers: 7
• No. Of Pwm Channels: 8
• Core Size: 16 Bit
• Program Memory Size: 416KB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

136
MB96300 Series
*1: Set AV
*2: If DV
*3: V
*4:
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,
analog inputs does not exceed AV
power V
current to/from a input is limited by some means with external components, the I
rating. Input/output voltages of high current ports depend on DV
I
Use within recommended operating conditions.
Use at DC voltage (current)
The +B signal should always be applied a limiting resistance placed between the +B signal and the
The value of the limiting resistance should be set so that when the +B signal is applied the input current to
Note that when the microcontroller drive current is low, such as in the power saving modes, the +B input
When using the LCD controller, No +B signal must be applied to any LCD I/O pin (including unused
Sample recommended circuits:
Applicable to all general purpose I/O pins (GP00_0 to GP17_7)
microcontroller.
the microcontroller pin does not exceed rated values, either instantaneously or for prolonged periods.
potential may pass through the protective diode and increase the potential at the VCC pin, and this may affect
other devices.
supply is provided from the pins, so that incomplete operation may result.
supply voltage may not be sufficient to operate the Power reset (except devices with persitant low voltage
reset in internal vector mode).
SEG/COM pins).
FME/EMDC- 2007-02-12
Note that if the +B input is applied during power-on, the power supply is provided from the pins and the resulting
and V
Note that if a +B signal is input when the microcontroller power supply is off (not fixed at 0 V) , the power
CC
CC
+B input (0V to 16V)
is powered before V
O
CC
temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
and V
should not exceed (D)V
before DV
CC
to the same voltage. Make sure that AV
CC
. It is not necessary to set V
CC
, then SMC I/O pin state is undefined. To avoid this, we recommend to always
resistance
CC
Limiting
CC
+ 0.3 V. V
when the power is switched on.
I
should not exceed the specified ratings. However if the maximun
CC
Preliminary Specification
and DV
Protective Diode
CC
does not exceed V
CC
to the same value.
CC,
R
of other ports on V
V
CC
P-ch
N-ch
CC
CLAMP
MB96300_shortspec.fm
and that the voltage at the
rating supercedes the V
CC.
I