T1620000 Red Lion Controls, T1620000 Datasheet - Page 10

• Manufacturer Part Number: T1620000
• Description: Process/Temperature Controller
• Manufacturer: Red Lion Controls
• Type: Temperaturer

Specifications of T1620000

• Operating Temperature Max: 50°C
• Operating Temperature Min: 0°C
• Temperature Accuracy ±: 0.3%
• Output Voltage Max: 7V
• Output Voltage Min: 4V
• Controller Input: Thermocouple Or RTD
• Brand/series: T16 Series
• Dimensions: 49.5mmW×49.5mmH×115.3mmD
• Enclosure Rating: IP65
• Input Type: RTD/Thermocouple
• Ip Rating: IP65
• Memory: EEPROM
• Mounting Type: Panel
• Output Type: Digital/SSR
• Power, Rating: 8 VA
• Primary Type: Controller
• Special Features: EEPROM
• Standards: cURus, CE
• Termination: Screw
• Voltage, Supply: 85 to 250 VAC
• Thermocouple Type: J, K, T, E, R, S, B, N, C And Linear MV
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Integral Time, Derivative Time, Digital Filter, Control Output Dampening
Time, and Relative Gain (Heat/Cool) values appropriate to the characteristics of
the process. This parameter allows front panel starting YES or stopping NO of
Auto-Tune. For more information, see PID Tuning Explanations.
Alarm 1 and the down key resets Alarm 2.
in the Hidden Loop. The arrow keys are used to select the parameter module (1-
9). To enter a specific module press
In the Configuration Loop, CNFP will alternate with the parameter number in the
bottom display. The Temperature/Process Value is shown in the top display.
parameter names in the module. To change a parameter’s selection/value, press
the arrow keys while the parameter is displayed. In the modules, the top display
shows the parameter name, and the bottom display shows the selection/value.
Use
committed to permanent memory until the controller is returned to the Display
Loop. If a power loss occurs before returning to the Display Loop, the new
values must be entered again.
pressing
key allows re-entrance to the Configuration Loop. Whenever
momentarily appears as the parameters are stored to permanent memory and the
controller returns to the Display Loop.
7.0 P
tUNE
The Auto-Tune procedure of the controller sets the Proportional Band,
ALrS
With alarm models, the alarms can be manually reset. The up key resets
To access the Configuration Loop, press the up key when CNFP/NO is displayed
After entering a parameter module, press
At the end of each module, the controller returns to CNFP/NO. At this location,
to enter any selection/values that have been changed. The change is not
1-2
NO
again returns the display to the the Display Loop. Pressing the Up
ROGRAMMING
NO YES
1-2
AUTO-TUNE START
ALARMS RESET
while the module number is displayed.
to advance through the
CONFIGURATION LOOP
: C
is pressed, End
ONFIGURATION
10
Code will appear here. By entering the proper Code, access to the Configuration
Loop is permitted (with a negative Code value, the Hidden Loop can be
accessed without the use of a code). With the factory setting of 0 or with an
active User Input configured for Program Lock (PLOC), Access Code will not
appear here. An active user input configured for Program Lock (PLOC) always
locks out the Configuration Loop, regardless of Access Code.
CodE
If the Access Code is set from -1 to -125, in Lockout Module 3-LC, Access
0
-1
to
ACCESS CODE
-125
L
OOP