CS1W-CN625 Omron, CS1W-CN625 Datasheet - Page 69

• Manufacturer Part Number: CS1W-CN625
• Description: CBL,PROG
• Manufacturer: Omron

Specifications of CS1W-CN625

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Transfer the local network table to the relay
Uploading
PLC
Connect online to the relay PLC.
Unit/port to enable accessing it.
Unit/port to enable accessing it.
Create the local network table.
Connect to a Communications
Connect to a Communications
Upload the network structure.
Upload the network structure.
PLC via the serial connection.
Start the CX-Integrator.
Switch the target PLC.
The network configuration of another PLC can be read via the PLC that was first
connected to the computer (known as the relay PLC). To read another PLC’s network
configuration, switch the target PLC from the relay PLC to the desired PLC connected.
At this point, it is possible to upload the configuration of the network (including
component parameters) of the network connected to that target PLC.
Note: When accessing a target PLC other than the relay PLC, observe the following two pre-
Overall Procedure
• Always create local network tables and transfer them to the relay PLC and target PLC.
• When specifying a target PLC in another network, register both local network tables and
relay network tables in all of the PLCs on the path between the relay PLC and target PLC.
Network
cautions, set routing tables, and transfer them to the PLCs.
Configurations from Target PLCs other than the Relay
Right-click the desired network in the Online
Connection Information Window and select
Connect from the pop-up menu.
Right-click the target PLC in the
Network Structure Window and select
Connect to this PLC.
Example: Select Component − Auto
Online from the menu bar to automatically
connect online using a serial connection.
Required when there is
more than one Network
Communications Unit in
the relay PLC.
Create the local network tables
between the relay PLC and target PLC.
Transfer the routing tables to all PLCs
and relay network tables.
2-1
Basic Procedures
Required when the target PLC
is on a remote network.
2-5