FLASH-CAN-64P-350-PMC Fujitsu, FLASH-CAN-64P-350-PMC Datasheet - Page 11

• Manufacturer Part Number: FLASH-CAN-64P-350-PMC
• Description: Fujitsu 16-Bit Multifunctional Board
• Manufacturer: Fujitsu

Specifications of FLASH-CAN-64P-350-PMC

• Silicon Manufacturer: Fujitsu
• Features: In-Circuit Serial Flash Programming, High-Speed CAN Transceiver, UART Interfaces
• Silicon Family Name: MB90350, MB96350
• Silicon Core Number: MB90F35x, MB96F35x
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.3 Power Supply Voltage (JP: 29, 34)
Vcc and GND (Vss) are both connected to the edge-connector (X4) in order to supply
additional circuitry. However, if the current requirements exceed the maximum ratings of the
on board voltage regulator LM317T, the board also can be powered externally via the edge-
connector. In that case, take care of the input-voltage. Neither a voltage regulation nor an
over-voltage-protection does exist for an external power-supply.
JP29 Power Supply selection
JP34 This Jumper is used to connect the Vcc supply voltage to the IC.
Default: JP29 = 1-2, JP34 = closed,
By default, the on-board Voltage regulation is used and the microcontroller is powered.
© Fujitsu Microelectronics Europe GmbH
JP34 (MCUVcc)
JP29 (Vcc)
Jumper
In case that the board is powered via the VG-connector (X4),
a regulated 5 V power source has to be used.
Connecting an Ampere-meter allows measuring of the power-supply-current of the
microcontroller (Icc).
ON (closed)
OFF (open)
Setting
1 - 2
2 - 3
Chapter 4 Jumpers and Switches
FLASH-CAN-64P-350-PMC
Description
On-board voltage regulation
External power-supply from X4 pin 1
Power supply Vcc connected to IC
Disconnected from Power supply Vcc
- 11 -
UG-960008-10