ASDL-3023-021 Avago Technologies US Inc., ASDL-3023-021 Datasheet - Page 20

Infrared Transceivers SFF FIR+RC Front w/o Shield

ASDL-3023-021

Manufacturer Part Number
ASDL-3023-021
Description
Infrared Transceivers SFF FIR+RC Front w/o Shield
Manufacturer
Avago Technologies US Inc.
Datasheet

Specifications of ASDL-3023-021

Wavelength
885 nm, 875 nm
Continual Data Transmission
4 Mbit/s
Transmission Distance
30 cm
Radiant Intensity
50 mW/sr
Half Intensity Angle Degrees
15 deg
Pulse Width
4 us, 1.6 us
Maximum Rise Time
60 ns, 600 ns
Maximum Fall Time
60 ns, 600 ns
Led Supply Voltage
- 0.3 V to 6 V
Operating Voltage
2.4 V to 3.6 V
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 25 C
Dimensions
7.5 mm x 2.75 mm x 1.75 mm
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
General mobile application processor
The transceiver is directly interface with the micropro-
cessor provided its support infrared communication
commonly known as Infrared Communications Port
(ICP). The ICP supports both SIR data rates up to 115.2kps
and sometimes FIR data with data rates up to 4Mbps.
The remote control commands can be sent one of the
available General Purpose IO pins or the UART block
with IrDA functionality. It should be should be observed
that although both IrDA data transmission and Remote
control transmission is possible simultaneously by the
hardware, hence the software is required to resolve this
issue to prevent the mixing and corruption of data while
being transmitted over the free air. The above Figure 3
illustrates a reference interfacing to implement both IR
and RC functionality with ASDL-3023.
Figure 3. ASDL-3023 configuration with general mobile architecture processor
0
IR_RXD
IR_TXD
IOVCC
GPIO
GPIO
100Kohm
IOVCC
GND
GND
100Kohm
VCC
CX3
GND
CX5
VLED
GND
R1
CX4
R3
Remote Control Operation
The ASDL-3023 is spectrally suited to universal remote
control transmission function at 940nm typically. Remote
control applications are not governed by any standards,
owing to which there are numerous remote codes
in market. Each of those standards results in receiver
modules with different sensitivities, depending on the
carries frequencies and responsively to the incident light
wavelength. Remote control carrier frequencies are in
the range of 30KHz to 60KHz (for details of some the fre-
quently used carrier frequencies, please refer to AN1314).
Some common carrier frequencies and the correspond-
ing SA-1110 UART frequency and baud rate divisor are
shown in Table 3.
Table 3.
Remote Control Carrier
Frequency (KHz)
0
,
6,6.7,8,9.,40
56
TXD_RC
RXD
IOVCC
SD
TXD_IR
VCC
VLEDA
CX1
CX2
HSDL3021
GND
GND
SA-1110 UART
Frequency (KHz)
8.8
.9
8.4
57.6
Baud Rate
Divisor
8
7
6
4

Related parts for ASDL-3023-021