CS1W-CRM21 Omron, CS1W-CRM21 Datasheet - Page 267

• Manufacturer Part Number: CS1W-CRM21
• Description: CS1 CompoNet Master
• Manufacturer: Omron

Specifications of CS1W-CRM21

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

6-5
Note
Note
Editing Master Parameters
Before making device I/O allocations to the master, the device must be added to the
Network Configuration Window, regardless of whether or not it has been registered as
a slave with the master. Refer to 2-5 Creating Virtual Network Configurations Offline
for information on creating a virtual network.
Device parameters are classified into master device parameters and slave device
parameters. This section description provides information on how to edit master
device parameters.
The master device parameters that can be edited include slave device I/O allocations
to the master, communication cycle time settings, and connection settings.
The following two methods can be used to edit parameters for the master.
The CX-Integrator allows settings, such as the following function settings, for the
OMRON CS1W-DRM21(-V1) DeviceNet Unit, CJ1W-DRM21 DeviceNet Unit,
CVM1-DRM21-V1 DeviceNet Master Unit, and C200HW-DRM21-V1 DeviceNet
Master Unit.
When transferring parameters edited for the CVM1-DRM21-V1,C200HW-DRM21-V1,
or 3G8F7-DRM21, however, they can be transferred from the CX-Integrator only by
going through a CS/CJ-series PLC.
I/O Allocations
Communication Cycle
Time
Connections
Device Information
Compare
Message Timer
Slave Function
Startup Remote I/O
Communications
Explicit Message
Communications
When editing parameters on the CX-Integrator for the CVM1-DRM21-V1,
C200HW-DRM21-V1, or 3G8F7-DRM21, download them to the Master Unit by going
through a CS/CJ-series PLC.
1) Parameter Wizard
2) Editing Parameters
Note 1. The same function can be achieved with the setting to enable/disable the master
Function
The Parameter Wizard is an interactive interface that makes I/O allocations
possible in order of node addresses.
Parameters can be edited to allocate I/O and make settings as required,
including the communication cycle time, connection, and device information
check settings.
2. Explicit message communications is possible whether or not registration has been
function.
made on the scan list.
Parameter Wizard
---
(Component - Parameter
Parameter Wizard
- Wizard)
Setting method
I/O Allocation (OUT) and
Message Timer Tab
Slave Function Tab
I/O Allocation (IN) Tabs
Communication Cycle
Time Tab
Advanced Setup Button
in General Tab
General Tab
Parameter editing
Parameter - Edit)
(Component -
6-5 Editing Master Parameters
CS1W-DRM21 (-V1) or
CJ1W-DRM21
(See note 1.)
(See note 2.)
OK
OK
OK
OK
OK
OK
C200HW-DRM21-V1 or
CVM1-DRM21-V1
OK
OK
OK
OK
No
No
No
No
6-15