CS8900A-IQZR Cirrus Logic Inc, CS8900A-IQZR Datasheet - Page 13

• Manufacturer Part Number: CS8900A-IQZR
• Description: Ethernet ICs IC 10Mbps Ethernet Controller 5V
• Manufacturer: Cirrus Logic Inc

Specifications of CS8900A-IQZR

• Ethernet Connection Type: 10Base- 2, 10Base- 5, 10Base- F, 10Base- T
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Product: Ethernet Controllers
• Standard Supported: IEEE 802.3
• Data Rate: 10 Mbps
• Maximum Operating Temperature: + 85 C
• Package / Case: LQFP-100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS271F5
ISA Bus Interface
SA[0:19] - System Address Bus, Input PINS 37-48, 50-54, 58-60.
SD[0:15] - System Data Bus, Bi-Directional with 3-State Output PINS 65-68, 71-74, 27-
24, 21-18.
RESET - Reset, Input PIN 75.
AEN - Address Enable, Input PIN 63.
MEMR - Memory Read, Input PIN 29.
MEMW - Memory Write, Input PIN 28.
MEMCS16 - Memory Chip Select 16-bit, Open Drain Output PIN 34.
REFRESH - Refresh, Input PIN 49.
IOR - I/O Read, Input PIN 61.
CS8900A
Crystal LAN™ Ethernet Controller
Lower 20 bits of the 24-bit System Address Bus used to decode accesses to CS8900A
I/O and Memory space, and attached Boot PROM. SA0-SA15 are used for I/O Read
and Write operations. SA0-SA19 are used in conjunction with external decode logic for
Memory Read and Write operations.
Bi-directional 16-bit System Data Bus used to transfer data between the CS8900A and
the host.
Active-high asynchronous input used to reset the CS8900A. Must be stable for at least
400 ns before the CS8900A recognizes the signal as a valid reset.
When TEST is high, this active-high input indicates to the CS8900A that the system
DMA controller has control of the ISA bus. When AEN is high, the CS8900A will not
perform slave I/O space operations. When TEST is low, this pin becomes the shift
clock input for the Boundary Scan Test. AEN should be inactive when performing an
IO or memory access and it should be active during a DMA cycle.
Active-low input indicates that the host is executing a Memory Read operation.
Active-low input indicates that the host is executing a Memory Write operation.
Open-drain, active-low output generated by the CS8900A when it recognizes an
address on the ISA bus that corresponds to its assigned Memory space (CS8900A
must be in Memory Mode with the MemoryE bit (Register 17, BusCTL, Bit A) set for
MEMCS16 to go active). 3-Stated when not active.
Active-low input indicates to the CS8900A that a DRAM refresh cycle is in progress.
When REFRESH is low, MEMR, MEMW, IOR, IOW, DMACK0, DMACK1, and
DMACK2 are ignored.
When IOR is low and a valid address is detected, the CS8900A outputs the contents
of the selected 16-bit I/O register onto the System Data Bus. IOR is ignored if
REFRESH is low.
CIRRUS LOGIC PRODUCT DATASHEET
13