TDA6101Q/N3,112 NXP Semiconductors, TDA6101Q/N3,112 Datasheet - Page 7

• Manufacturer Part Number: TDA6101Q/N3,112
• Manufacturer: NXP Semiconductors

Specifications of TDA6101Q/N3,112

• Single Supply Voltage (typ): Not RequiredV
• Single Supply Voltage (min): Not RequiredV
• Single Supply Voltage (max): Not RequiredV
• Mounting: Through Hole
• Lead Free Status / RoHS Status: Compliant

Philips Semiconductors
Notes
1. If the difference between V
2. SVRR: The ratio of the change in supply voltage to the change in input voltage when there is no change in output
Cathode output
The cathode output is protected against peak currents
(caused by positive voltage peaks during high-resistance
flash) of 5 A maximum with a charge content of 100 C.
The cathode is also protected against peak currents
(caused by positive voltage peaks during low-resistance
flash) of 10 A maximum with a charge content of 100 nC.
Flashover protection
The TDA6101Q incorporates protection diodes against
CRT flashover discharges that clamp the cathode output
pin to the V
has to be within the operating range of 180 to 210 V to
ensure that the Absolute Maximum Rating for V
250 V will not be exceeded during flashover. To limit the
diode current, an external 820
resistor in series with the cathode output and a 2 kV spark
gap are needed (for this resistor-value, the CRT has to be
connected to the main PCB). This addition produces an
increase in the rise and fall times of approximately 5 ns
and a decrease in the overshoot of approximately 3%.
1995 Feb 07
SYMBOL
O
SVRRH
SVRRL
Video output amplifier
v
voltage.
DDH
cathode output voltage overshoot
high supply voltage rejection ratio
low supply voltage rejection ratio
pin. The DC supply voltage at the V
PARAMETER
DDL
carbon high-voltage
and V
ip
is less than 7 V, overshoot cannot be specified.
DDH
DDH
of
V
V
wave; f < 1 MHz;
t
see Figs 4 and 5; note 1
f < 50 kHz; note 2
f < 50 kHz; note 2
r
pin
ocAC
ocDC
= t
f
= 40 ns;
7
= 100 V (p-p);
= 100 V square
CONDITIONS
V
1. With a capacitor >20 nF with good HF behaviour
2. With a capacitor >10 F on the picture tube base print
V
1. With a capacitor >20 nF with good HF behaviour
Switch-off behaviour
The switch-off behaviour of the TDA6101Q is defined:
when the bias current becomes zero, at V
than approximately 5 V, all the output pins
(pins 7, 8 and 9) will be high.
DDH
DDL
(e.g. foil). This capacitance must be placed as close
as possible to pins 6 and 4, but definitely within 5 mm.
(common for three output stages).
(e.g. ceramic). This capacitance must be placed as
close as possible to pins 2 and 4, but definitely within
10 mm.
to GND must be decoupled:
to GND must be decoupled:
MIN.
9
85
70
Preliminary specification
TYP.
TDA6101Q
DDL
MAX.
(pin 2) lower
%
dB
dB
UNIT