TDA9965HL/C4,151 NXP Semiconductors, TDA9965HL/C4,151 Datasheet - Page 11

• Manufacturer Part Number: TDA9965HL/C4,151
• Manufacturer: NXP Semiconductors

Specifications of TDA9965HL/C4,151

• Analog Front End Type: CCD
• Analog Front End Category: Video
• Interface Type: Serial (3-Wire)
• Sample Rate: 30MSPS
• Input Voltage Range: 2V
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (max): 5.25V
• Resolution: 12b
• Number Of Adc's: 1
• Power Supply Type: Analog/Digital
• Operating Temp Range: -20C to 75C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 48
• Package Type: LQFP
• Number Of Channels: 1
• Lead Free Status / RoHS Status: Compliant

Philips Semiconductors
Table 1 Serial interface programming
Notes
1. PGA gain register must always be refreshed after clamp code register content has been changed.
2. When pin CLPADC = HIGH (SD1 = 1; serial interface), the ADC input is clamped to the voltage level of V
When the power supplies increase from zero to V
Table 2 Standby selection
Note
1. In case an external regulator is used, it has to be switched off in standby mode in order to avoid an extra power
2004 Jul 05
Cut-off frequency of the CTH circuit is set to: code f
PGA gain control is set to: code G
Clamp code of the ADC is set to: code ADC
SHP and SHD sample on HIGH level; CLKADC activated with rising edge
CLPOB and CLPADC activated on HIGH level.
12-bit, 5.0 V, 30 Msps analog-to-digital
interface for CCD cameras
is connected to ground via a capacitor.
consumption of the TDA9965.
A1
0
0
1
1
ADDRESS BITS
PIN STDBY
HIGH
LOW
A0
0
1
0
1
PGA
clamp reference of ADC (SD0 to SD9), note 1
cut-off frequency of CTH (SD0 to SD3)
PGA gain control (SD0 to SD9)
edge control for pulses SHP, SHD, CLPOB, CLPADC and CLKADC (note 2):
= 0
SD0 = 1, SHP and SHD sample on LOW level
SD1 = 1, CLPADC and CLPOB activated on HIGH level
SD2 = 1, CLKADC activated with rising edge
CLP
DATA BITS SD9 to SD0
CC
= 0
, the init-on-power block initializes the circuit as follows:
co(CTH)
logic 0
active
11
= 0
SDATA BITS SD0 to SD9
4 mA (typical); note 1
84 mA (typical)
I
CCA
Product specification
+ I
CCD
TDA9965
ref
. Pin V
ref