CY7C63723-SXCT Cypress Semiconductor Corp, CY7C63723-SXCT Datasheet - Page 36

• Manufacturer Part Number: CY7C63723-SXCT
• Manufacturer: Cypress Semiconductor Corp

Specifications of CY7C63723-SXCT

• Lead Free Status / RoHS Status: Compliant

[3:0] to NAK IN-Status OUT mode (1110) after ACKing a valid
status stage OUT token. The firmware needs to update the mode
for the SIE to respond appropriately. See
on what modes will be changed by the SIE.
Any SETUP packet to an enabled endpoint with mode set to
accept SETUPs will be changed by the SIE to 0001 (NAKing).
Any mode set to accept a SETUP will send an ACK handshake
to a valid SETUP token.
Table 9. Decode table for
Document #: 38-08022 Rev. *D
Endpoint Mode
3
Legend:
Encoding
2
(SETUP, IN,OUT)
Received Token
1
0
To-
ken
Properties of incoming
count
The number of received
bytes
UC: unchanged
x: don’t care
available for Control endpoint only
Table
packet
buffer
The quality status of the DMA buffer
10: “Details of Modes for Differing Traffic Conditions”
The validity of the received data
dval
Table 8
Changes to the internal register made by the SIE as a result of
DTOG
Data 0/1 (Bit 7, Figure 18)
TX: transmit
RX: receive
for more details
DVAL
Data Valid (Bit 6, Figure 18)
COUNT
Bit[3:0], Figure 18
A disabled endpoint will remain disabled until changed by
firmware, and all endpoints reset to the Disabled mode (0000).
Firmware normally enables the endpoint mode after a SetCon-
figuration request.
The control endpoint has three status bits for identifying the
token type received (SETUP, IN, or OUT), but the endpoint must
be placed in the correct mode to function as such. Non-control
endpoints should not be placed into modes that accept SETUPs.
the incoming token
Setup
TX0: transmit 0-length packet
(Bit[7:5], Figure 16)
PID Status Bits
In
Out
Acknowledge transaction completed
(Bit4,Figure 16/3)
ACK
End Point
Mode
3
Endpoint Mode changed
by the SIE.
2 1 0
CY7C63722C
CY7C63723C
CY7C63743C
Re-
sponse
SIE’s Re-
sponse
Interrupt?
Page 36 of 53
Int
[+] Feedback