MCIMX31VKN5 Freescale, MCIMX31VKN5 Datasheet - Page 58

• Manufacturer Part Number: MCIMX31VKN5
• Manufacturer: Freescale

Specifications of MCIMX31VKN5

• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Compliant

Electrical Characteristics
4.3.14.2.2
The SENSB_VSYNC, SENSB_HSYNC, and SENSB_PIX_CLK signals are used in this mode. See
Figure
A frame starts with a rising edge on SENSB_VSYNC (all the timings correspond to straight polarity of the
corresponding signals). Then SENSB_HSYNC goes to high and hold for the entire line. Pixel clock is valid
as long as SENSB_HSYNC is high. Data is latched at the rising edge of the valid pixel clocks.
SENSB_HSYNC goes to low at the end of line. Pixel clocks then become invalid and the CSI stops
receiving data from the stream. For next line the SENSB_HSYNC timing repeats. For next frame the
SENSB_VSYNC timing repeats.
4.3.14.2.3
The timing is the same as the gated-clock mode (described in
except for the SENSB_HSYNC signal, which is not used. See
valid and will cause data to be latched into the input FIFO. The SENSB_PIX_CLK signal is inactive (states
low) until valid data is going to be transmitted over the bus.
58
43.
SENSB_DATA[9:0]
SENSB_PIX_CLK
SENSB_DATA[7:0]
SENSB_HSYNC
SENSB_VSYNC
SENSB_PIX_CLK
SENSB_VSYNC
Gated Clock Mode
Non-Gated Clock Mode
Start of Frame
Start of Frame
invalid
invalid
Figure 44. Non-Gated Clock Mode Timing Diagram
nth frame
nth frame
Figure 43. Gated Clock Mode Timing Diagram
MCIMX31/MCIMX31L Technical Data, Rev. 4.1
1st byte
1st byte
Active Line
n+1th frame
invalid
n+1th frame
Section 4.3.14.2.2, “Gated Clock
invalid
Figure
44. All incoming pixel clocks are
1st byte
1st byte
Freescale Semiconductor
Mode”),