ADM1070ARTZ Analog Devices Inc, ADM1070ARTZ Datasheet - Page 14

• Manufacturer Part Number: ADM1070ARTZ
• Manufacturer: Analog Devices Inc

Specifications of ADM1070ARTZ

• Linear Misc Type: Negative Voltage
• Family Name: ADM1070
• Package Type: SOT-23
• Operating Supply Voltage (min): -18V
• Operating Supply Voltage (max): -80V
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 1.6mm
• Product Height (mm): 1.15mm
• Product Length (mm): 2.9mm
• Mounting: Surface Mount
• Pin Count: 6
• Lead Free Status / RoHS Status: Compliant

ADM1070
Figure 13 shows the behavior of ADM1070 when a temporary
current fault occurs followed by a permanent current fault.
When the first overcurrent fault occurs, the first 100 mV spike
on the sense line can be seen. During the t
fault corrects itself. After this time period, a no fault condition is
detected and the limited consecutive counter is reset. GATE is
reasserted. When the overcurrent fault returns permanently, the
limited consecutive retry counter detects seven consecutive
faults and the part latches off.
In this way, the ADM1070 prevents nuisance shutdowns from
transient shorts of up to three seconds (typically), but will provide
latched shut-down protection from permanently shorted loads.
KELVIN SENSE RESISTOR CONNECTION
When using a low value sense resistor for high current measure-
ment, the problem of parasitic series resistance can arise. The
lead resistance can be a substantial fraction of the rated resis-
tance, making the total resistance a function of lead length. This
problem can be avoided by using a Kelvin sense connection.
This type of connection separates the current path through
the resistor and the voltage drop across the resistor. Figure 14
shows the correct way to connect the sense resistor between the
SENSE and V
Figure 13. Illustration of the PWM Ratio (t
KELVIN SENSE TRACES
SENSE
GATE
Figure 14. Kelvin Sensing with the ADM1070
CURRENT
FLOW FROM
LOAD
CH1
EE
T
Pins of the ADM1070.
100mV
B
N
SENSE
SENSE RESISTOR
ADM1070
CH2
5.00V
V
EE
OFF
M 500ms
time, this current
CURRENT
FLOW TO –48V
BACKPLANE
ON
/t
OFF
)
–14–
UV/OV AS ENABLE PIN
Connecting an open collector output to the UV/OV Pin means
that a TTL signal can be used to disable the part. In Figure 15,
the open collector output connects to EN. Driving the base of
the open collector device high enough to cause the UV/OV Pin
to be pulled below the undervoltage falling threshold of 0.86 V
typical will cause the pass transistor Q1 to be turned off.
–48V
EN
0V
Figure 15. UV/OV Used as Enable Input
R1
R2
UV/OV
TIMER
V
IN
ADM1070
R
DROP
SENSE
GATE
V
EE
C
LOAD
R
Q1
SENSE
REV. 0
V
OUT