668-0003-C Rabbit Semiconductor, 668-0003-C Datasheet - Page 203

• Manufacturer Part Number: 668-0003-C
• Description: IC CPU RABBIT2000 30MHZ 100PQFP
• Manufacturer: Rabbit Semiconductor

Specifications of 668-0003-C

• Rohs Status: RoHS non-compliant
• Processor Type: Rabbit 2000 8-Bit
• Speed: 30MHz
• Voltage: 2.7V, 3V, 3.3V, 5V
• Mounting Type: Surface Mount
• Package / Case: 100-MQFP, 100-PQFP
• Features: -
• Other names: 316-1004; 668-0003

A.1 The Rabbit Programming Port
The programming port provides a standard physical and electrical interface between a
Rabbit-based system and the Dynamic C programming platform. A special interface cable
and converter connects a PC serial port to the programming port. The programming port is
implemented by means of a 10-pin standard 2 mm connector. (Of course the user can
change the physical implementation of the connector if he so desires.) With this setup the
PC can communicate with the target, reset it and reboot it. The DTR line on the PC serial
interface is used to drive the target reset line, which should be drivable by an external
CMOS driver. The STATUS pin is used to by the Rabbit-based target to request attention
when a breakpoint is encountered in the target under test. The SMODE pins are pulled up
by a +5 V/+3 V level from the interface. They should be pulled down on the board when
the interface is not in use by approximately 5 kΩ resistors to ground. The target under test
provides the +5 V or +3 V to the interface cable which is used to power the RS-232 driver
and receiver.
Appendix A.1 The Rabbit Programming Port
T
HE
Figure A-1. Rabbit Programming Port
R
ABBIT
P
ROGRAMMING
A
PPENDIX
W
W
W
W
W
P
ORT
A.
197