PIC24FJ256GB210-I/PT Microchip Technology Inc., PIC24FJ256GB210-I/PT Datasheet - Page 183

• Manufacturer Part Number: PIC24FJ256GB210-I/PT
• Description: 100 TQFP 12x12x1mm TRAY, 16-bit, 256KB Flash, 96K RAM, USB
• Manufacturer: Microchip Technology Inc.

Specifications of PIC24FJ256GB210-I/PT

• A/d Inputs: 24 Channel, 10-bit
• Comparators: 3
• Cpu Speed: 16 MIPS
• Eeprom Memory: 0 Bytes
• Input Output: 84
• Interface: I2C/SPI/UART/USART/USB
• Memory Type: Flash
• Number Of Bits: 16
• Package Type: 100-pin TQFP
• Programmable Memory: 256K Bytes
• Ram Size: 98K Bytes
• Speed: 32 MHz
• Temperature Range: –40 to 85 °C
• Timers: 5-16-bit
• Voltage, Range: 2.2-3.6 V
• Lead Free Status / Rohs Status: RoHS Compliant part

11.0
The Timer1 module is a 16-bit timer, which can serve
as the time counter for the Real-Time Clock (RTC) or
operate as a free-running, interval timer/counter.
Timer1 can operate in three modes:
• 16-Bit Timer
• 16-Bit Synchronous Counter
• 16-Bit Asynchronous Counter
Timer1 also supports these features:
• Timer Gate Operation
• Selectable Prescaler Settings
• Timer Operation during CPU Idle and Sleep
• Interrupt on 16-Bit Period Register Match or
FIGURE 11-1:
 2010 Microchip Technology Inc.
Note:
modes
Falling Edge of External Gate Signal
TIMER1
SOSCO/
This data sheet summarizes the features
of this group of PIC24F devices. It is not
intended to be a comprehensive reference
source. For more information, refer to the
“PIC24F
Section 14. “Timers” (DS39704). The
information in this data sheet supersedes
the information in the FRM.
SOSCI
T1CK
Set T1IF
Family
16-BIT TIMER1 MODULE BLOCK DIAGRAM
TGATE
1
0
Reference
Reset
Equal
SOSCEN
Comparator
Manual”,
TMR1
PR1
PIC24FJ256GB210 FAMILY
Q
Q
Gate
Sync
CK
T
CY
D
Figure 11-1 presents a block diagram of the 16-bit timer
module.
To configure Timer1 for operation:
1.
2.
3.
4.
5.
6.
Set the TON bit (= 1).
Select the timer prescaler ratio using the
TCKPS<1:0> bits.
Set the Clock and Gating modes using the TCS
and TGATE bits.
Set or clear the TSYNC bit to configure
synchronous or asynchronous operation.
Load the timer period value into the PR1
register.
If interrupts are required, set the interrupt enable
bit, T1IE. Use the priority bits, T1IP<2:0>, to set
the interrupt priority.
TSYNC
1x
01
00
0
1
TON
TGATE
TCS
Sync
TCKPS<1:0>
1, 8, 64, 256
Prescaler
2
DS39975A-page 183