PEB24901HV12 Lantiq, PEB24901HV12 Datasheet - Page 49

• Manufacturer Part Number: PEB24901HV12
• Manufacturer: Lantiq

Specifications of PEB24901HV12

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Semiconductor Group
3.4.2.3
SSP
LTD
RES
TEST
0011 Line Termination Disable. In the LT, the Quad IEC DFE-T stops
1101 Reset. Any stored settings except the driver pins are erased. The
0101 Send Single Pulses. Thechannel goes to the power-up state and
0110 Test mode. The channel goes from any mode and at any state of
IOM-2 C/I codes to the Quad IEC DFE-T for Test and Maintenance
transmitting signals (INFO U0) on the correwsponding channel,
ignoring awake signals. The channel is set to power-down. This
command is used to keep the Uk0 interface deactivated (e.g. due to a
continuous fault).
corresponding channel goes to the power-up state, but no line signal
will be sent out. An applied low on RES pin, while TSP is low, has the
same effect for all four channels together.
sends single pulses with a period of 1 ms. An applied high on the TSP
pin, while RES is high, has the same effect on all four channels
together.
activation to the transparent state (sends INFO U4/U5). An applied low
on RES pin, while TSP is high, has the same effect on all four
channels together.
48
PEB 24901
02.95