PEB24901HV12 Lantiq, PEB24901HV12 Datasheet - Page 54
![no-image](/images/manufacturer_photos/0/3/379/lantiq_sml.jpg)
PEB24901HV12
Manufacturer Part Number
PEB24901HV12
Description
Manufacturer
Lantiq
Datasheet
1.PEB24901HV12.pdf
(71 pages)
Specifications of PEB24901HV12
Lead Free Status / Rohs Status
Supplier Unconfirmed
3.4.4.1
In the following list, C/I-channel infos are omitted.
AWR
AWT
FRJ
TE
U0
U1
U2
U3
U4H
3.4.4.2
The output of the Quad IEC DFE-T, e.g. infos on Uk0 or C/I-channel contents, usually
depends only on the given state of the Quad IEC DFE-T control unit. In some states,
several outputs are possible depending on input. If RES is not set to low or TSP isn’t set
to high, only the control of loops is state independent and is evaluated from the C/I-
channel input.
ARL
AR2
AR4
Any other C/I-channel input, low at RES or high at TSP, causes the analog loop to be
opened and the M symbol to be set to zero.
3.4.4.3
In this section, each state is described with its inputs, its outputs and its meaning. Unless
described otherwise, the activation controller performs the following actions:
l
l
l
l
l
Semiconductor Group
No RESET of the Quad IEC DFE-T
The adaption of receiver coefficients is disabled
The RDS counter of frames with code violations is reset and disabled
The received user data is given transparently to the IOM-2 interface
The Quad IEC DFE-T is in power-up
Awake signal (INFO U1W or U2W) detected
INFO U1W of U2W has been sent out
Frame jump, detected by receive or transmit buffer, at least one IOM-2 frame
(18 bit) is repeated or omitted caused by receive or transmit buffer over/
underflow
Timer ended, the started timer has run out
INFO U0 detected
INFO U1 detected
NFO U2 detected
INFO U3 detected
INFO U4H detected
causes the chip to be reset and the analog loop to be closed.
causes the M symbol continuously to be set to plus polarity in the LT.
Transit Conditions and their Appreviations
Control of the Analog Loop and Loop Commands on Uk0
Description of the Activation/Deactivation States of Quad IEC DFE-T
causes the M symbol to be set to alternating plus and zero polarity in the LT
53
PEB 24901
02.95