ST72C334N2B6 STMicroelectronics, ST72C334N2B6 Datasheet - Page 101

• Manufacturer Part Number: ST72C334N2B6
• Description: Microcontrollers (MCU) Flash 8K SPI/SCI
• Manufacturer: STMicroelectronics

Specifications of ST72C334N2B6

• Data Bus Width: 8 bit
• Program Memory Type: Flash
• Program Memory Size: 8 KB
• Data Ram Size: 384 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 44
• Number Of Timers: 16 bit
• Operating Supply Voltage: 3.2 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• Package / Case: SDIP-56
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / Rohs Status: No

ST7 ADDRESSING MODES (Cont’d)
7.1.6 Indirect Indexed (Short, Long)
This is a combination of indirect and short indexed
addressing modes. The operand is referenced by
its memory address, which is defined by the un-
signed addition of an index register value (X or Y)
with a pointer value located in memory. The point-
er address follows the opcode.
The indirect indexed addressing mode consists of
two sub-modes:
Indirect Indexed (Short)
The pointer address is a byte, the pointer size is a
byte, thus allowing 00 - 1FE addressing space,
and requires 1 byte after the opcode.
Indirect Indexed (Long)
The pointer address is a byte, the pointer size is a
word, thus allowing 64 Kbyte addressing space,
and requires 1 byte after the opcode.
Table 21. Instructions Supporting Direct,
Indexed,
Addressing Modes
Short Instructions Only
LD
CP
AND, OR, XOR
ADC, ADD, SUB, SBC
BCP
CLR
INC, DEC
TNZ
CPL, NEG
BSET, BRES
BTJT, BTJF
SLL, SRL, SRA, RLC,
RRC
SWAP
CALL, JP
Long and Short
Instructions
Indirect
and
Clear
Increment/Decrement
Test Negative or Zero
1 or 2 Complement
Bit Operations
Bit Test and Jump Opera-
tions
Shift and Rotate Operations
Swap Nibbles
Call or Jump subroutine
Load
Compare
Logical Operations
Arithmetic Addition/subtrac-
tion operations
Bit Compare
Indirect
Functio n
Function
Indexed
7.1.7 Relative mode (Direct, Indirect)
This addressing mode is used to modify the PC
register value, by adding an 8-bit signed offset to
it.
The relative addressing mode consists of two sub-
modes:
Relative (Direct)
The offset is following the opcode.
Relative (Indirect)
The offset is defined in memory, which address
follows the opcode.
Available Relative Direct/
JRxx
CALLR
Indirect Instructions
ST72334J/N, ST72314J/N, ST72124J
Conditional Jump
Call Relative
Function
101/125