ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 112

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

9
11
13
10,
12, 14
O - Output from programmer
I - Input to programmer
P - Passive e.g. GROUND and power rails
N/C - Not connected
1.3 Connecting Remote Status LEDs
If the programmer is to be mounted inside a Test Fixture, then it is likely that the programmer ‘Status
LEDs’ will not be visible. It is possible to mount a set of so-called ‘Remote Status LEDs’ on the
outside of the Test Fixture so that they are visible to the operator. These LEDs should be wired to the
relevant pins of the ‘Remote Control Port’ as detailed in the table below.
Pin
No
1 + 2
3 + 4
5 + 6
Please note:
The Remote LEDs can be directly connected across pins 1+2, 3+4 and 5+6 of the without using any
series resistor. The programmer has a 330 ohm resistor in the anode and cathode leg on the main
programmer circuit board.
96
REMOTE FAIL SIGNAL O
REMOTE OK SIGNAL
REMOTE BUSY
SIGNAL
GROUND (0V)
Programmer
Pin name
REMOTE PASS LED
REMOTE BUSY LED
REMOTE FAIL LED
O
I
P
Input /
Output
P
P
P
ISPnano Series Programmer - User Manual – V1.11 – 12
Notes
Connect to Remote ‘PASS’ LED:
Connect to Remote ‘BUSY’ LED:
Connect to Remote ‘FAIL’ LED:
•
•
•
•
•
•
•
•
•
•
•
•
•
This is the TTL-4-wire Remote Control Port
‘FAIL’ signal.
Connect to ‘FAIL’ input on Remote System
This is the TTL-4-wire Remote Control Port ‘OK’
signal
Connect to ‘OK / PASS’ input on Remote
System
This is the TTL-4-wire Remote Control Port ‘OK’
signal
Connect to ‘BUSY’ input on Remote System
Connect to GROUND on Remote System
pin 1 - LED anode (+ve)
pin 2 - LED cathode (-ve)
pin 3 – LED anode (+ve)
pin 4 – LED cathode (-ve)
pin 5 - LED anode (+ve)
pin 6 – LED cathode (-ve)
th
May 2011