ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 33

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

1.10 ISPnano - Front panel connections
1.10.1 Overview
The illustration below details the function of each of the connectors on the rear panel of the
programmer.
1.10.2 Programmer Remote Control Port
The ‘Remote Control’ port features all the signals required to implement the following functionality:
i. Remote Control of the programmer via 4 TTL signals: START, BUSY, PASS, FAIL
This allows the programmer to be controlled by an external system using 4 TTL control signals such
as a PLC.
ii. Remote Programmer Status LEDs
This allows the programmer Status LEDs to be mounted remotely from the programmer. e.g. on the
Test Fixture panel itself.
iii. Remote LID Start Switch
This input allows can be connected to the “Lid Switch” on a Test Fixture and allows the programmer
to automatically commence programming when the Test Fixture lid is closed.
Please see Appendix 2 for the pin-out of this connector.
ISPnano Series Programmer - User Manual – V1.11 – 12
Programmer Remote Control Port
•
•
PASS, BUSY, FAIL are also on this
port. This allows LEDs to mounted on
the lid of the Test Fixture for easier
visibility.
The “Remote Status LEDs”
programmer from e.g. an ATE via a
“4-wire TTL Interface”.
This port is used to control the
•
•
A ‘Remote Display / Keypad Module’ can also be connected
to this port allowing the programmer to be remote controlled.
The connector is a 4-pin RJ11 connector.
•
Target ISP Connection Port
•
•
•
•
Controlled Target Vcc Supply
Multiplexed for SPI, JTAG, UART, BDM, PDI
This Port features all the Target I/O Signals."
5 x Programmer controlled I/O lines
1 x Programmer Output line (e.g. Relay control)
Dedicated 2-wire I2C Port
th
May 2011
17