WD30-AT001 Omron, WD30-AT001 Datasheet - Page 53

• Manufacturer Part Number: WD30-AT001
• Description: REMOTE WIRELESS ANTENNA'S DNET
• Manufacturer: Omron

Specifications of WD30-AT001

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: WD30AT001

Deciding the Antenna Installation Position
2-7-1
Hole diameter: 9mm min.
Example of installation inside a control panel
9-dia. connectors
9. 24VDC, 1A
Antenna cable length: 2m
R38 min.
1. The wireless unit (1) is installed in the control panel using the two M4
2. The 16-point input terminal (2) is installed in the control panel using DIN
3. The antennas are attached to the control panel with magnets and the an-
4. A shielded T-branch connector (4) is connected to the wireless unit (1), and
5. Wire the DeviceNet cable (of 6), the terminal block with a terminating re-
6. Wire the contact signals of the 16-point input terminal (2) to the PLC’s out-
7. Multi-drop
connection connector
XW4B-05C4-TF-D
screws provided.
track or two M4 screws.
tenna cables are fed into the control panel where they are connected to the
wireless unit (1) with connectors.
a shielded terminating resistor (5) and a cable with one connector (6) are
connected to it.
sistor (8), and the DC24V, 1A power supply (for the wireless unit (1) and
the 16-point input terminal (2)) to the multi-drop connection connector (7).
put card (PNP). Use a separate power supply for I/O.
R38 min.
80
150
Separate by at
least 62mm.
Do not bend for
40mm min.
8. Terminal block with
terminating resistor
DRS1-T
85
54
1. Wireless unit
5. Shielded
4. Shielded T-branch
2. 16-point input
6. Cable with one
terminating resistor
DRS2-1
connector
DCN2-1
terminal
DRT1-ID16
connector
(0.5m)
DCA1-5CNC5F1
3. Magnet-base antennas
(The larger the separation distance
between the antennas, the greater
the utilization of the diversity effect.)
Antennas attached to the control
panel enclosure (metal surface)
with powerful magnets.
250mm min.
PLC output
card (PNP)
Section 2-7
41