M29F010B70N6 Micron Technology Inc, M29F010B70N6 Datasheet - Page 6

• Manufacturer Part Number: M29F010B70N6
• Manufacturer: Micron Technology Inc

Specifications of M29F010B70N6

• Lead Free Status / Rohs Status: Not Compliant

Summary description
1
6/35
Summary description
The M29F010B is a 1 Mbit (128Kb x8) non-volatile memory that can be read, erased and
reprogrammed. These operations can be performed using a single 5V supply. On power-up
the memory defaults to its Read mode where it can be read in the same way as a ROM or
EPROM.
The memory is divided into blocks that can be erased independently so it is possible to
preserve valid data while old data is erased. Each block can be protected independently to
prevent accidental Program or Erase commands from modifying the memory. Program and
Erase commands are written to the Command Interface of the memory. An on-chip
Program/Erase Controller simplifies the process of programming or erasing the memory by
taking care of all of the special operations that are required to update the memory contents.
The end of a program or erase operation can be detected and any error conditions
identified. The command set required to control the memory is consistent with JEDEC
standards.
Chip Enable, Output Enable and Write Enable signals control the bus operation of the
memory. They allow simple connection to most microprocessors, often without additional
logic.
The memory is offered in PLCC32, TSOP32 (8 x 20mm) packages and it is supplied with all
the bits erased (set to ’1’).
In order to meet environmental requirements, ST offers the M29F010B in ECOPACK
packages. ECOPACK packages are Lead-free. The category of second Level Interconnect
is marked on the package and on the inner box label, in compliance with JEDEC Standard
JESD97.
The maximum ratings related to soldering conditions are also marked on the inner box label.
ECOPACK is an ST trademark. ECOPACK specifications are available at: www.st.com.
M29F010B
®