ISL5216KI-1 Intersil, ISL5216KI-1 Datasheet - Page 33

• Manufacturer Part Number: ISL5216KI-1
• Description: Digital Down Converter 196-Pin BGA
• Manufacturer: Intersil

Specifications of ISL5216KI-1

• Package: 196BGA
• Operating Temperature: -40 to 85 °C

ADD(2:0)
0
1
2
3
0
1
2
3
PINS
WR
WR
WR
WR
RD
RD
RD
RD
33
Indirect Write Holding Register, Bits 15:0.
Indirect Write Holding Register, Bits 31:16.
Indirect Write Address Register for Internal Target Register (Generates a write strobe to transfer contents of the
Write Holding Register into the Target Register specified by the Indirect Address, see also Tables of Indirect
Address Registers).
Indirect Read Address Register (Used to select the Read source of data - uses the same register as Direct
Address 2 but generates a read strobe (for RAMs and AGC) as needed instead of a write strobe).
Indirect Read, Bits 15:0.
Indirect Read, Bits 31:16.
Read Register (FIFO) - Reads FIFO data from output section (This location reads output data in the order
loaded in Global Control Indirect Address Registers F820-F83F. The FIFO is automatically incremented to the
next data location at the end of each read).
Status Register
TABLE OF MICROPROCESSOR DIRECT READ/WRITE ADDRESSES
P(15:0)
15:13
11:6
5:2
12
1
0
Unused.
BIST signature comparison result: 1= success (signatures match)
Read non-bus input pins (ENIx, RESET, SYNCI).
11 RESET (Note: This bit is inverted with respect to the RESET input pin).
10 ENIA.
9 ENIB.
8 ENIC.
7 ENID.
6 SYNCI.
Mask revision number. ISL5216 devices return 3 or higher (0, 1 and 2 were used for
HSP50216).
Level detector integration done. Active high.
New FIFO output data available (used for polling mode vs interrupt mode) Active low.
ISL5216
REGISTER DESCRIPTION
BIT DESCRIPTION
July 13, 2007
FN6013.3