S1D13705F00A200 Epson, S1D13705F00A200 Datasheet - Page 151

• Manufacturer Part Number: S1D13705F00A200
• Manufacturer: Epson

Specifications of S1D13705F00A200

• Operating Supply Voltage (typ): 3.3/5V
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Package Type: TQFP
• Pin Count: 80
• Mounting: Surface Mount
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 5.5V
• Lead Free Status / Rohs Status: Compliant

1: 1375CFG CONFIGURATION PROGRAM
3-4
• Format 2
• Frame Repeat - is a feature for EL panel support.
• MOD Count
• FPLINE Start - specifies the delay, in 8 pixel resolution, from the end of a line of display data
• FPFRAME Start - specifies the number of lines between the last line of display data (FPDAT)
• FPLINE / FPFRAME Polarity - these settings control the sync pulse direction of the FPLINE
8-bit single color panels typically use one of two data clocking formats arbitrarily named
“format 1” and “format 2”. Selecting “format 2” instructs the S1D13705 to use the second color
panel data format.
Most newer panels and, to date, all color panels smaller than 640x480 use “format 2”. Setting
this attribute incorrectly will result in a garbled display but will not damage the panel. The
display may appear “cut in half” or possibly horizontally skewed.
This option is STN specific and is disabled if TFT is selected. It is also disabled if the panel type
selected to be 4-bit data or monochrome.
EL panels require a frame of repeated data as the cue to switch polarization. Without this change
in polarization panel quality deteriorates.
When Frame Repeat is selected an internal counter causes the periodic repeat of one frame of
modulated panel data. At a frame rate of 72 Hz the repeat period is roughly one hour. When not
selected the modulated image is never consecutively repeated.
This option is STN specific and is disabled if TFT is selected.
This setting is for passive panels only and is generally only required for older monochrome
panels. When set to “0” (default) the MOD output signal toggles every FPFRAME.
This field is a TFT specific setting and is disabled if an STN panel is chosen.
This field is a TFT specific setting and is disabled if an STN panel is chosen.
Select the appropriate pulse direction for the panel being connected. Selecting 'Lo' results in an
active low sync pulse while 'Hi' results in an active high pulse.
These settings are TFT specific and are disabled when STN panel is selected. When an STN
panel type is selected the pulse directions are preset to +ve, +ve.
- determines the data clocking format for “8 Bit” single color panels.
- specifies the number of FPLINE pulses between toggles of the MOD
signal.
(FPDAT) to the leading edge of FPLINE.
and the leading edge of FPFRAME.
and FPFRAME pulses in TFT modes.
EPSON
S1D13705F00A UTILITIES (X27A-B-001-01)