AT83C5134 Atmel Corporation, AT83C5134 Datasheet - Page 118

• Manufacturer Part Number: AT83C5134
• Manufacturer: Atmel Corporation

Specifications of AT83C5134

• Max. Operating Frequency: 32 MHz
• Cpu: 8051-12C
• Max I/o Pins: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 1
• Sram (kbytes): 1.25
• Eeprom (bytes): 512
• Operating Voltage (vcc): 2.7 to 3.6
• Timers: 4
• Mask Rom (kbytes): 8
• Watchdog: Yes

21.10.2
118
AT83C5134/35/36
USB Interrupt Control System
Table 21-2.
As shown in Figure 21-16, many events can produce a USB interrupt:
• TXCMPL: Transmitted In Data (see
• RXOUTB0: Received Out Data Bank 0 (see
• RXOUTB1: Received Out Data Bank 1 (only for Ping-pong endpoints) (see
• RXSETUP: Received Setup (see
• STLCRC: STALLED (only for Control, Bulk and Interrupt endpoints) (see
• SOFINT: Start of Frame Interrupt
• WUPCPU: Wake-Up CPU Interrupt
• SPINT: Suspend Interrupt
when the Host accept a In packet.
hardware when an Out packet is accepted by the endpoint and stored in bank 0.
page
stored in bank 1.
an SETUP packet is accepted by the endpoint.
125). This bit is set by hardware when a STALL handshake has been sent as requested by
STALLRQ, and is reset by hardware when a SETUP packet is received.
Interrupt Enable Register” on page
Frame packet has been received.
Interrupt Enable Register” on page
detected on the USB bus, after a SUSPEND state.
Enable Register” on page
on the USB bus.
125). This bit is set by hardware when an Out packet is accepted by the endpoint and
IPHUSB
0
0
1
1
Priority Levels
122.). This bit is set by hardware when a USB suspend is detected
(See “USBIEN Register USBIEN (S:BEh) USB Global Interrupt
IPLUSB
(See “USBIEN Register USBIEN (S:BEh) USB Global
Table 21-9 on page
0
1
0
1
122.). This bit is set by hardware when a USB Start of
122.). This bit is set by hardware when a USB resume is
(See “USBIEN Register USBIEN (S:BEh) USB Global
Table 21-9 on page
Table 21-9 on page
USB Priority Level
0
1
2
3
Lowest
Highest
125). This bit is set by hardware when
125). This bit is set by hardware
125). This bit is set by
Table 21-9 on page
Table 21-9 on
7683C–USB–11/07