AT90PWM316 Atmel Corporation, AT90PWM316 Datasheet - Page 260

• Manufacturer Part Number: AT90PWM316
• Manufacturer: Atmel Corporation

Specifications of AT90PWM316

• Flash (kbytes): 16 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 12
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 27
• Ext Interrupts: 4
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 10
• Adc Speed (ksps): 125
• Analog Comparators: 3
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 1
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 105
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 1
• Pwm Channels: 12
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

22. Digital to Analog Converter - DAC
22.1
7710F–AVR–09/11
Features
•
•
•
•
•
•
The AT90PWM216/316 features a 10-bit Digital to Analog Converter. This DAC can be used for
the analog comparators and/or can be output on the D2A pin of the microcontroller via a dedi-
cated driver.
This allow to drive (worst case) a 1nF capacitance in parallel with a resistor higher than 33K load
with a time constant around 1us. Response time and power consumption are improved by
reducing the load (reducing the capacitor value and increasing the load resistor value (The best
case is a high impedance)).
The DAC has a separate analog supply voltage pin, AV
0.3V from V
pin.
The reference voltage is the same as the one used for the ADC,
– ADMUX” on page
age reference may be externally decoupled at the AREF pin by a capacitor for better noise
performance.
10 bits resolution
8 bits linearity
+/- 0.5 LSB accuracy between 150mV and AVcc-150mV
Vout = DAC*Vref/1023
The DAC could be connected to the negative inputs of the analog comparators and/or to a
dedicated output driver.
Output impedance around 100 Ohm.
CC
. See the paragraph
249.. These nominally 2.56V Vref or AV
“ADC Noise Canceler” on page 243
CC
. AV
CC
AT90PWM216/316
are provided On-chip. The volt-
CC
See “ADC Multiplexer Register
must not differ more than ±
on how to connect this
260