SAM9XE128 Atmel Corporation, SAM9XE128 Datasheet - Page 712

• Manufacturer Part Number: SAM9XE128
• Manufacturer: Atmel Corporation

Specifications of SAM9XE128

• Flash (kbytes): 128 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

39.5.1.2
39.5.1.3
712
AT91SAM9XE128/256/512 Preliminary
USB Bus Transactions
USB Transfer Event Definitions
Each transfer results in one or more transactions over the USB bus. There are three kinds of
transactions flowing across the bus in packets:
As indicated below, transfers are sequential events carried out on the USB bus.
Table 39-3.
Notes:
A status transaction is a special type of host-to-device transaction used only in a control transfer.
The control transfer must be performed using endpoints with no ping-pong attributes. According
to the control sequence (read or write), the USB device sends or receives a status transaction.
Control Transfers
Interrupt IN Transfer
(device toward host)
Interrupt OUT Transfer
(host toward device)
Isochronous IN Transfer
(device toward host)
Isochronous OUT Transfer
(host toward device)
Bulk IN Transfer
(device toward host)
Bulk OUT Transfer
(host toward device)
1. Setup Transaction
2. Data IN Transaction
3. Data OUT Transaction
1. Control transfer must use endpoints with no ping-pong attributes.
2. Isochronous transfers must use endpoints with ping-pong attributes.
3. Control transfers can be aborted using a stall handshake.
USB Transfer Events
(1) (3)
(2)
(2)
• Setup transaction > Data IN transactions > Status
• Setup transaction > Data OUT transactions > Status
• Setup transaction > Status IN transaction
• Data IN transaction > Data IN transaction
• Data OUT transaction > Data OUT transaction
• Data IN transaction > Data IN transaction
• Data OUT transaction > Data OUT transaction
• Data IN transaction > Data IN transaction
• Data OUT transaction > Data OUT transaction
OUT transaction
IN transaction
6254C–ATARM–22-Jan-10