TDA7319 STMicroelectronics, TDA7319 Datasheet - Page 7

• Manufacturer Part Number: TDA7319
• Description: IC PROCESSOR AUDIO DGTL 20DIP
• Manufacturer: STMicroelectronics
• Type: Tone and Volume Controlr

Specifications of TDA7319

• Applications: Automotive Audio
• Mounting Type: Through Hole
• Package / Case: 20-DIP (0.300", 7.62mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3970-5

I
Data transmission from microprocessor to the
TDA7319 and viceversa takes place thru the 2
wires I
lines SDA and SCL (pull-up resistors to positive
supply voltage must be externally connected).
Data Validity
As shown in fig. 3, the data on the SDA line must
be stable during the high period of the clock. The
HIGH and LOW state of the data line can only
change when the clock signal on the SCL line is
LOW.
Start and Stop Conditions
As shown in fig.4 a start condition is a HIGH to
LOW transition of the SDA line while SCL is
HIGH. The stop condition is a LOW to HIGH tran-
sition of the SDA line while SCL is HIGH.
Byte Format
Every byte transferred to the SDA line must con-
tain 8 bits. Each byte must be followed by an ac-
knowledge bit. The MSB is transferred first.
Data Validity on the I
Timing Diagram of I
Acknowledge on the I
2
C BUS INTERFACE
2
C BUS interface, consisting of the two
2
CBUS
2
CBUS
2
CBUS
Acknowledge
The master ( P) puts a resistive HIGH level on the
SDA line during the acknowledge clock pulse (see
fig. 5). The peripheral (audioprocessor) that ac-
knowledges has to pull-down (LOW) the SDA line
during the acknowledge clock pulse, so that the
SDA line is stable LOW during this clock pulse.
The audioprocessor which has been addressed
has to generate an acknowledge after the recep-
tion of each byte, otherwise the SDA line remains
at the HIGH level during the ninth clock pulse
time. In this case the master transmitter can gen-
erate the STOP information in order to abort the
transfer.
Transmission without Acknowledge
Avoiding to detect the acknowledge of the audio-
processor, the P can use a simplier transmis-
sion: simply it generates the 9th clock pulse with-
out checking the slave acknowledging, and then
sends the new data.
This approach of course is less protected from
misworking and decreases the noise immunity.
TDA7319
7/16