TSV912 STMicroelectronics, TSV912 Datasheet - Page 11

• Manufacturer Part Number: TSV912
• Description: Rail to rail input/output widebandwidth op-amps
• Manufacturer: STMicroelectronics

Specifications of TSV912

• Low Power Consumption: 820 μA typ
• High Output Current: 35 mA
• Low Input Offset Voltage: 1.5 mV max (A grade)

TSV91x, TSV91xA
3
3.1
3.2
3.3
Application information
Driving resistive and capacitive loads
These products are low-voltage, low-power operational amplifiers optimized to drive rather
large resistive loads above 2 kΩ .
In a follower configuration, these operational amplifiers can drive capacitive loads up to
100 pF with no oscillations. When driving larger capacitive loads, adding a small in-series
resistor at the output can improve the stability of the device
recommended in-series resistor values). Once the in-series resistor value has been
selected, the stability of the circuit should be tested on bench and simulated with the
simulation model.
Figure 18. In-series resistor vs. capacitive load
PCB layouts
For correct operation, it is advised to add 10 nF decoupling capacitors as close as possible
to the power supply pins.
Macromodel
An accurate macromodel of the TSV91x is available on STMicroelectronics’ web site at
www.st.com. This model is a trade-off between accuracy and complexity (that is, time
simulation) of the TSV91x operational amplifiers. It emulates the nominal performances of a
typical device within the specified operating conditions mentioned in the datasheet. It helps
to validate a design approach and to select the right operational amplifier, but it does not
replace on-board measurements.
Doc ID 12584 Rev 8
(Figure 18
Application information
shows the
11/22