STM32F101ZG STMicroelectronics, STM32F101ZG Datasheet - Page 37

• Manufacturer Part Number: STM32F101ZG
• Description: Mainstream Access line, ARM Cortex-M3 MCU with 1 Mbyte Flash, 36 MHz CPU
• Manufacturer: STMicroelectronics

Specifications of STM32F101ZG

• Conversion Range: 0 to 3.6 V
• Peripherals Supported: timers, ADC, DAC, SPIs, I2Cs and USARTs
• Systick Timer: a 24-bit downcounter

STM32F101xF, STM32F101xG
Table 8.
1. All main power (V
2. Negative injection disturbs the analog performance of the device. See note in
3. Positive injection is not possible on these I/Os. V
4. I
5. When several inputs are submitted to a current injection, the maximum I
Table 9.
supply, in the permitted range.
characteristics.
never be exceeded. A negative injection is induced by V
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
positive and negative injected currents (instantaneous values). These results are based on
characterization with I
I
INJ(PIN)
I
INJ(PIN)
Symbol
INJ(PIN)
Symbol
I
I
VDD
VSS
I
T
IO
STG
T
J
must never be exceeded. This is implicitly insured if V
(2)
Current characteristics
Thermal characteristics
Total current into V
Total current out of V
Output current sunk by any I/O and control pin
Output current source by any I/Os and control pin
Injected current on five volt tolerant pins
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
DD
, V
Storage temperature range
Maximum junction temperature
DDA
INJ(PIN)
IN
>V
) and ground (V
DD
maximum current injection on four I/O port pins of the device.
while a negative injection is induced by V
Doc ID 17143 Rev 2
DD
SS
/V
Ratings
SS
DDA
ground lines (sink)
, V
Ratings
SSA
power lines (source)
IN
maximum must always be respected. I
) pins must always be connected to the external power
(4)
IN
<V
SS
(3)
IN
.
maximum is respected. If V
(1)
(1)
INJ(PIN)
IN
<V
INJ(PIN)
(5)
Electrical characteristics
Section 5.3.18: 12-bit ADC
SS
–65 to +150
is the absolute sum of the
.
value. A positive
Value
150
-5/+0
INJ(PIN)
Max.
 25
± 25
150
150
± 5
25
IN
maximum
must
Unit
Unit
37/108
°C
°C
mA